Electronics Forum | Mon Jan 07 13:06:16 EST 2002 | mregalia
My company has been doing its hand soldering using drip bottles for application of no-clean flux. This has created quite a few problems, especially on our microwave boards. I want to convert us over to flux pens. Does anyone have any suggestions or c
Electronics Forum | Mon Jan 07 21:07:00 EST 2002 | davef
Using a flux pen sounds like a good idea. Comments are: * I assume you�re talking aqueous flux. If not, some NC flux pens leave white residues. Nearly all of 15 samples suffered to varying degrees with white residues. * Use the same flux that you
Electronics Forum | Tue Jan 08 17:29:20 EST 2002 | davef
Your research is on track. NC flux needs to reach activation temperature. Also, do not depend on the corrosion characteristics associated with the flux classification (ie, L1, L0, M1, M0, etc.), until the flux is activated by exposure to soldering
Electronics Forum | Tue Jan 08 11:28:30 EST 2002 | mregalia
We use NC flux exclusively for SMT and wave soldering. And it is a fairly old formula from Multicore, though we are currently qualifying a new formula. The automated soldering does not appear to be a problem. It is only the hand soldering that causes
Electronics Forum | Sat Sep 02 10:18:16 EDT 2000 | Dave F
Yanno, I just thought of an addition to #3 above. Back in the ol' days (before computer drawing) there were rooms full of people, generally guys (with plastic pocket protectors holding colored pens and ... ) leaning on drawing boards, doing whatever
Electronics Forum | Tue Jun 14 08:46:54 EDT 2011 | mbnetto
Hi Everybody, In our process we use syring flux for repair the boards, both SMT and PTH. I would like to know with your experiences what kind of flux is better for SMT and PTH repair, PEN or Syring flux??
Electronics Forum | Tue Jun 06 15:19:39 EDT 2006 | muse95
For some, not all, hand assembly, we use additional flux. We use a flux pen in certain applications and liquid flux in other applications - you can't just say switch to a flux pen, it isn't always adequate. Most flux pens are ORL0 with very low sol
Electronics Forum | Fri Oct 25 04:06:56 EDT 2002 | kcngoi
Hi Adam, Excessive heat from soldering iron will left the burn mark of RMA flux. The residue is hard to remove. Suggest to use the Flux pen for better control.
Electronics Forum | Mon Nov 04 12:50:23 EST 2002 | babe
Sorry for being late on the reply. Whatever you do, flux from the container or the manufacturers flux pens. Stick witht the same chemistry. Mixing chemistries, IE: different fluxes will create more problems in rework than you will see if you use the
Electronics Forum | Thu Aug 26 22:32:04 EDT 2004 | Indy
Hey, We have introduced a Cleaning Pen from Chemtronics. It removes excess flux after touch up.. This way the operator doesn't have to go everytime to the cleaning room.. Indy
.gif)