Electronics Forum | Tue May 07 15:30:41 EDT 2013 | bobpan
your card is probably bad.....you can ohm out the motor and cable if you want... z motor windings 1.36 ohms z motor cable and windings 1.82 ohms good luck
Electronics Forum | Wed Jul 06 09:10:55 EDT 2011 | bobpan
i have seen bad motor cables cause the problem......you can ohm them out to the driver cards or if you have extras....replace them Bob
Electronics Forum | Mon Jul 26 21:56:53 EDT 2004 | pdeuel
The camera is not driven from the motor cards. The camera is attached to what is called a forcer. For the Y axis there are two of them. One is wired backwards from the other. one of the forcers is connected to a flex chanell for the air and electrica
Electronics Forum | Thu Apr 17 11:59:59 EDT 2014 | briantmc
Hi all. A "newbie" on the forum, hopefully someone can help! I have a Quad IVc that has developed a problem on its Theta Axis. In performing the Homing routine it does not spin the nozzle through 360 deg as it should. It does a small turn ~45deg o
| 1 |
.gif)
winsouce.jpg)