Electronics Forum | Mon Oct 06 11:09:20 EDT 2014 | cyber_wolf
I dont have a schematic anymore but its most likely the SSR for that zone or the blower.
Electronics Forum | Wed Sep 11 17:16:17 EDT 2013 | saied
Hello, We would like to order this spare-part blower motor electrovert omni Excel for Speedline Technologies Electrovert, type: Omni Excel 7 Serial: 476219 Date: 4/04 and we would be thankful if you provide us the Service manul for your prod
Electronics Forum | Wed Sep 12 11:01:49 EDT 2007 | leemeyer
We have an Omni 7. We were having problems where blowers wouldn't start. Turned out to be the start capacitors and not the blowers. I replaced all of the caps and haven't had any issues since.
Electronics Forum | Mon Sep 01 04:55:20 EDT 2008 | benefon
Hello all Our Omni 5 has given the 'Cooling module high temp' warning twice during the past month. I suspect that the blower motor is the culprit but have not been able to verify this because the oven has started up normally after acknowledging the
Electronics Forum | Mon Jul 16 19:29:13 EDT 2007 | bga_kid
I have some advice...... rid your self of that beast. and try a OmniExcel
Electronics Forum | Thu Oct 25 11:15:55 EDT 2012 | aj
are you sure the zone 5 blower is running? sounds like it isnt.... no harm to check all blowers while you are at it.
Electronics Forum | Tue Sep 11 08:36:53 EDT 2007 | cyber_wolf
We seem to have a lot of blowers going bad on our Omni 10 lately. We run PB free and/or elevated sn/pb profiles on a regular basis. I am starting to suspect that the elevated zone temps are causing the blowers to fail. Has anyone else had this prob
Electronics Forum | Fri Jan 21 15:33:43 EST 2005 | Mark
>Hours mean nothing on these machines. Correct me if I am wrong but isn't it true that heaters and blowers (maybe valves) have a specific lifespan? I would think that parts in an oven with many hours on it are due to fail sooner than those in one wit
Electronics Forum | Thu Oct 25 10:05:05 EDT 2012 | kz9yyc
Hello all, I am having difficulty with an OmniExcel 10 oven. Zone 5 upper will not hold setpoint = 165C (it typically runs ~10C higher). Here is what I know: 1. The machine is not turning on zone 5 heat when temp is too high. 2. Zone 5 lower is
Electronics Forum | Mon Jan 22 12:24:36 EST 2007 | dave
thanks for reply. Problem sorted - Inverter for Bottom Blowers faulty. This did not give any error ! Dave.