Electronics Forum | Fri May 17 14:23:34 EDT 2002 | dason_c
I will convinced to change to the no clean process by environmental safe even though clean process is water soluble but it still produce the waste. Also, the BGA is not recommend to clean, if the flux is not completed removed from the board and elec
Electronics Forum | Tue May 28 08:34:00 EDT 2002 | Hussman69
Hello, I know I will probably get a dozen "check the archives" answers, but what the heck. What is YOUR typical polarity mark for SMT devices? Do you use silk screen or cut a corner off a pad? How do you identify pin one on ICs? Let me know and
Electronics Forum | Wed May 29 15:44:59 EDT 2002 | Jacob Lacourse
Hi, All Our board design requires us to selectively plate some connector pads with gold. The problem is we have changed board houses and they charge a heafty amount to mask the rest of the board. One option is to allow them to plate the whole bo
Electronics Forum | Wed Jun 12 06:27:39 EDT 2002 | seje
Pete & Ken Thanks guys. So it's getting clear that AXI programming and fine tunig takes a lot of time, and that's something that we don't have too much to spend. Next question will be, that can anyone recommed any automatical inspection system for h
Electronics Forum | Fri Jun 07 02:43:35 EDT 2002 | madreindeer
Thanks for answers....In Euroland (My place)it is not so clear.And this is confusing: There is 3 different comittee�s in Europe. First says 1 of January 2007.Second says 1 of January 2006, and third one says that any of these will do. Also we get a
Electronics Forum | Fri Jun 07 17:27:50 EDT 2002 | nuezmaster
I am having some diffuculty convincing our exec. staff that by increasing our personel on the floor, we will actually improve our machine efficiency. We currently have seven lines, four of them have two P&P machines in line. At this point there is
Electronics Forum | Thu Jun 13 15:43:19 EDT 2002 | mjabure
The major draw at NEPCON was the the machine manufacturers. With most of the big players going to the APEX shows, NEPCON attendance has seemed to slow down quite a bit. Although APEX wasn't very busy either. With the industry in it's current state no
Electronics Forum | Thu Jun 20 19:27:28 EDT 2002 | surinder
Hi Dave, I am agree with you,but one of my customer want to know the difference in terms of rework/Quality,if we go for Glue process in place of solder paste and want to see some data We have board ,which have Through hole components and smt comp. on
Electronics Forum | Wed Jun 26 12:21:30 EDT 2002 | dason_c
You can check with Alpha. ie Alpha had 3 different grade of the 63/37 bar, Vaculoy, Vaculoy SMG and HiFlo. You can consult with them and see which one fit for your current supplier. http://www.alphametals.com/products/solder_barwire/index.html Go
Electronics Forum | Mon Jul 08 05:10:56 EDT 2002 | bayanbaru
We are assigned to set-up an ESD control at a new site. There are a few proposals in mind, they are 1) conductive flooring with heel strap or shoe 2) wrist strap with continuos monitoring 3)the normal wrist strap with the common grounding point. Woul