Electronics Forum | Wed Jan 20 09:12:03 EST 2016 | anel_elektronik
Hallo, Following problem with CP40CV conveyor: If I start production, put first PCB and after placement PCB is transported to the output of conveyor and I take it out. Next PCB after placement is waiting endless. All sensors are ok. Looks as if t
Electronics Forum | Thu Sep 29 19:45:23 EDT 2011 | edwaterfall01
The conveyor is programmed to turn off the belts and go into an error condition after 30 seconds if the board has not passed the output sensor on the conveyor. The intent is to indicate a board jam and prevent damage to the board or belts. On convey
Electronics Forum | Fri Mar 24 08:10:12 EST 2006 | mapell
Hi AR Nice job on the chain/rail cleaning. I would contact Speedline Electrovert tech support, 800.737.8110 to assist in trouble shooting. They can walk you through using a meter to measure input and output current to the SC card and make sure tha
Electronics Forum | Fri Jul 29 17:41:35 EDT 2016 | ddina
I appreciate your response. I kind of read about it, and made sure nothing sensor-wise is activated by mistake on the process of zeroing. Right now the machine is in this set up, and the rear rail is all the way to the back stop. So the sensor on the
Electronics Forum | Thu Jul 28 15:43:48 EDT 2016 | ddina
Recently started setting up our GSM 4681A system, and one of the machines comes up with the message "WAITING FOR OUTPUT BOARD TRANSFER TO COMPLETE" after the Zeroing process has been started. Machine has all the defaults set, two SMEMA connected univ
Electronics Forum | Mon Aug 31 15:21:04 EDT 2015 | zombee
Dear Users! I have a Topaz pick&place machine, but the conveyor motor is not working. 1st test - production: Start production in "operation" menu: if I put the PCB the entrace of machine, the assembly head-bank picks up the first 8 components (prec
Electronics Forum | Thu Aug 21 10:14:57 EDT 2014 | malard
I know my Sanyo machine is no longer made, and the Sanyo connector has died out, but I have an ASYS TRM-03 conveyor that I want to connect up to it, in the manual it references Sanyo for its output format by adjusting a couple of jumpers. However the
Electronics Forum | Thu Jun 16 22:18:35 EDT 2005 | davef
Cooling may require muff fans positioned over that output conveyor of the oven.
Electronics Forum | Thu Dec 17 22:42:44 EST 2009 | voytek
Is it possible to run GSM without input/output conveyors? I would have to bypass SMEMA connection I think. All help appreciated.
Electronics Forum | Fri Oct 13 12:43:40 EDT 2000 | Brian
Can anyone help? We have reconfigured our production lines and I could use some help for machine communications on 2 production lines. Does anyone know how to get a handshake for the following equipment? Asm Line #1)UIC 4713D output to input Fuji
