Electronics Forum | Sat Jul 23 02:16:52 EDT 2022 | poly
Is there are reason for going for larger (or smaller) boards when designing panels for use with a chain conveyor oven? My panels range from 0.6mm 2 layer (for touch with hatched ground) to 1.6mm 4 layer. I'm planning to go for smaller panels to reduc
Electronics Forum | Mon Jul 25 19:12:17 EDT 2022 | proceng1
I generally do not design an array larger than 10" x 12". Other than just thermal mass, the one issue to watch with extra length is if the array is so large that it spans multiple heat zones at the same time. We have panels that are up to 48" l
Electronics Forum | Tue Jul 26 13:34:18 EDT 2022 | emeto
10x6 to 12x8 is ideal for most equipment. Too small panel is not good too for handling by humans and machines. 1.6mm you can use as and depanel on the router. 0.6mm you might need to run on SMT carrier, if you see warping.
Electronics Forum | Mon Mar 20 15:41:00 EDT 2023 | oclsc
Hallo SMTnet. We have just bought a VXS Air 3.2/634 Rehm reflow oven. We are wondering why the conveyor chain in the oven is still running two days after the "Auto OFF" precedure/program has been activated. In this case the oven set to "Auto Off" Fr
Electronics Forum | Tue Mar 21 11:57:27 EDT 2023 | stephendo
Or after a preset amount of time. Maybe the oven has a setting somewhere that is not set propely.
Electronics Forum | Mon Mar 20 22:08:24 EDT 2023 | tey422
For reflow oven to "auto off" it has to go through the cool down; it should be off went the cool off temperature is reached. Perhaps you need to 1st check if something prevent the oven reach the cool off temp (both hardware & software).
Electronics Forum | Tue Aug 11 16:18:41 EDT 2009 | dyoungquist
Oberon (oberonlube.com) makes a high temperature chain lube (oil). When our Heller oven was installed, we were told to use this as the replacement when our original volume of chain oil ran out. I do not know the price for it.
Electronics Forum | Tue Aug 11 08:19:48 EDT 2009 | cyber_wolf
Has anyone located an alternate source for the Fuchs Stabylan oil that Vitronics calls for ? $65 a pint seems a little stiff.
Electronics Forum | Sat Feb 15 10:25:50 EST 2014 | jdengler
Can the oven do 400C? If so do them in the oven. Jerry
Electronics Forum | Thu Feb 13 08:08:41 EST 2014 | cyber_wolf
The manual says to bake the edge chains at 400C to clean them. Is anybody doing this ? I need to take my edge chains to a heat treat facility to clean them ? I don't want to spray oven cleaner on them as they appear to be plated with nickel or so
