Electronics Forum | Mon Sep 19 09:31:28 EDT 2016 | emeto
Whatever the cause is, will be fixed by applying less paste. So Homeplate it is.
Electronics Forum | Mon Sep 19 21:35:54 EDT 2016 | shriram
Appreciate your suggestion. NSMD pads are used for this design, the anomalies we found are 1. the trace running between pads has a lesser solder mask height compared the other area of the pads. 2. the NSMD pads doesnot have a trench close to pad e
Electronics Forum | Mon Sep 19 01:57:28 EDT 2016 | shriram
Hi guys, Problem: Mid chip solder balling. Component affected: 0603 caps only Defect is PCB specific (Meaning only one PCB is affected as the aperture is standard for that component). As a containment I'll give a home plate design for the compo
Electronics Forum | Mon Sep 19 09:16:24 EDT 2016 | markhoch
Hi Shriram, Are you saying that there is a trace running between the pads for this 0603 capacitor? If so, this design may be causing a gasketing issue between the stencil and the PCB. The uneven height prevents the stencil from sitting flat on the PC
Electronics Forum | Tue Aug 26 17:50:52 EDT 2014 | dkrawchuk
Hi, We have some boards that we apply an underfill to a BGA. Some boards have underfill that covered the surrounding passives. The customer is concerned that the different expansion rates will damage the passives. Does anyone know of a company th
Electronics Forum | Fri Mar 19 13:26:19 EST 1999 | Scott Cook
| Hi folks, | | I am looking for inputs on a long-standing problem encountered in our shop: Bottom-side parts (passives) falling off in the Wave...where the only remnants of the part is a flattened glue dot of proper diameter and volume, and somet
Electronics Forum | Wed Mar 17 19:58:00 EST 1999 | Marc Ruggiero
Hi folks, I am looking for inputs on a long-standing problem encountered in our shop: Bottom-side parts (passives) falling off in the Wave...where the only remnants of the part is a flattened glue dot of proper diameter and volume, and sometimes f
Electronics Forum | Thu Mar 18 13:54:30 EST 1999 | John
| Hi folks, | | I am looking for inputs on a long-standing problem encountered in our shop: Bottom-side parts (passives) falling off in the Wave...where the only remnants of the part is a flattened glue dot of proper diameter and volume, and somet
Electronics Forum | Thu Mar 18 17:18:22 EST 1999 | Earl Moon
| | Hi folks, | | | | I am looking for inputs on a long-standing problem encountered in our shop: Bottom-side parts (passives) falling off in the Wave...where the only remnants of the part is a flattened glue dot of proper diameter and volume, and
Electronics Forum | Fri Mar 19 05:08:24 EST 1999 | Vinesh Gandhi
Hey Marc, I am not sure about the kind of process you are following. Is it Gluing+paste printing on the bottom side or just gluing on the bottom side and paste printing on the top side. The relationship which I could think of between Bottom side
