Electronics Forum | Wed May 17 16:02:53 EDT 2000 | Mark J. Braska
Is there any data on the total cost of labeling PC boards. Included in this cost would be the labels, ribbons,printers & maintenance,software, and engineering & operator expenses(fully burdened). I am searching for an independant analysis of the co
Electronics Forum | Tue Mar 27 04:39:27 EDT 2012 | andrzej
Have you got some experience with using laser (CO2 or fiber one) to label with barcode your PCBs ? So far I thought it is easy process but now we do tests with many PCBs covered with diffrent soldermasks and fiber laser as well as CO2 has same probl
Electronics Forum | Thu Mar 29 09:47:12 EDT 2012 | blnorman
In a previous life we burned bar-codes on PCB with a CO2 laser. Initially we placed a small white epoxy pad to burn the code into. After some experimentation we found that we could eliminate the epoxy and just burn through the soldermask and the un
Electronics Forum | Sat Jun 25 15:20:03 EDT 2016 | skipper6567
I have a mini/micro transformer that is mounted on a pcb inside my lowrance gps/plotter. I have removed it from the pcb. It has 5 through hole pins, 3 pins out bottom one side and 2 pins out bottom on opposite side. The transformer has yellow tape ar
Electronics Forum | Wed Oct 05 13:54:07 EDT 2011 | jillatchoice
I have a ProPen P3000 for marking metals and plastics. Please email if interested.
Electronics Forum | Wed Oct 05 16:08:12 EDT 2011 | tombstonesmt
We use various Zebra printers for 2D barcodes with great success.
Electronics Forum | Wed Oct 05 13:30:01 EDT 2011 | leemeyer
We are required by most of our customers to apply a serial # to the boards that we build. As the PC boards have been getting smaller and open areas on the board are getting scarce we have been forced into using smaller and smaller labels. I am lookin
Electronics Forum | Thu Jan 13 13:15:47 EST 2005 | msjohnston1
I'm looking to automate my PCB labeling. Anyone have any insight (especially first-hand users) into this type of system?
Electronics Forum | Tue Mar 20 15:59:15 EDT 2007 | blnorman
We use preprinted labels and laser coding. For PCB we laser mark with CO2 (NdYAG for the aluminum heat spreaders). We either have an epoxy legend to burn out or we burn the solder mask to expose the copper ground plane underneath. Laser is a much
Electronics Forum | Fri Aug 01 15:45:11 EDT 2008 | jdengler
We use a Brady label PTL-13-457 out of a TLSPClink printer on a 63/37 PCB. This label is supposed to go to Pb free temp but we have not actually tested it yet. - Jerry
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
winsouce.jpg)
.gif)