Electronics Forum | Fri May 21 09:48:30 EDT 2010 | tomg_fla
Am looking for a dispensable water soluble solder mask or peelable solder mask that can be dispensed and be run through a reflow oven with no swelling or degradation. Any leads on any materials or manufacturers to contact?
Electronics Forum | Mon May 24 12:05:53 EDT 2010 | deanm
Did you try Techspray Wondermask W? It is water soluble and can probably be transferred from the bottle to an EFD type syringe for dispensing (we use the P and the PL that way). As far as if it will swell through the reflow, I don't know. We don't us
Electronics Forum | Mon Jul 24 15:50:51 EDT 2023 | proceng1
I am going to be using a pressurized dispenser for Chemtronics CM1 peelable mask. I need to find a solvent that will work for flushing the system. I tried Xylene that we have here and it does ok, but not as good as I'd hoped. It works very well fo
Electronics Forum | Wed Oct 20 20:38:30 EDT 1999 | Dreamsniper
I am looking for sources of temporary peelable solder mask to mask/cover holes on a circuit bd that need not be soldered during wave soldering�..must have distributors in Australia. I�ve contacted some down here but they do not have products package
Electronics Forum | Thu Sep 13 20:34:02 EDT 2018 | davef
What does your supplier say? How will they make you whole?
Electronics Forum | Thu Sep 13 13:04:52 EDT 2018 | jrs192
Hello! Recently started buying PCBs with peelable mask to remove the need for Kapton tape. Had no issues with our first batch, but our supplier has over-cured the second batch - it comes off in tiny bits, and is stuck in the holes. After timing the
Electronics Forum | Mon Sep 24 11:28:55 EDT 2018 | etmpalletguy
Use a solder pallet, the pallet will mask off the locations required, thus eliminating the need for any kind of masking!! You've eliminated the need to apply, but you still have to peel off, not much of time saver. Pallets can be used for batch or s
Electronics Forum | Fri Sep 14 07:46:34 EDT 2018 | charliedci
If it is "wondermask" made by Techspray, it is supposed to be water soluble. It being overcured (we have experienced this before), water will not touch it. We used acetone which softened it up to remove it with an orange stick. We apply it ourselves
Electronics Forum | Fri Oct 22 10:35:56 EDT 1999 | Graham Naisbitt
Armin, I can supply you but wont. Why not? Because these materials have a short shelf life when packed into syringes. Your local supplier should be able to provide them but he will be obliged to make up a batch of 2 - 300 to be economical - but they
Electronics Forum | Mon Jan 26 11:41:04 EST 2004 | pbarton
Some questions: Is the peelable/spot masking only being applied to the earthing points on the one side or to both sides? Is the peelable mask you are using specifically designed for coating masking or is it the same as that you use for masking sold
.gif)
winsouce.jpg)