Electronics Forum | Wed Jun 24 10:17:50 EDT 2020 | kylehunter
> Hi. Guessing that you are operational by now? If > not, consider to use BGA definition and use the > editor to define where the bottom side pads are > or are not. Just our 2 bits input. The Assembleon > X / Yamaha units are quite
Electronics Forum | Thu Jul 15 15:57:39 EDT 2021 | kumarb
Here you go: https://we.tl/t-qQkEpE8H3p Suggest to also contact Trans-tec USA for any questions that you may have about this tool or any other. As an owner of the machine from Assembleon / Yamaha - they offer support. They have been great to suppo
Electronics Forum | Tue Apr 10 02:57:53 EDT 2018 | rob
Yes I would, most of our old Yamaha machines (before 2005) will do 30-35 microns @ 3 sigma with the fine camera option. Our Jukis with His res camera's will hit it too. You should be OK with most things after 1997 with the right camera choice (whic
Electronics Forum | Thu Dec 05 08:49:43 EST 2002 | pjc
Yamaha YV100Xg is the Topaz XII YV100X is Topaz X YV100II is Topaz YV88Xg is Emerald XII YV88X is Emerald X YVL88II is Emerald YV180Xg is Sapphire XII
Electronics Forum | Tue Oct 21 05:28:37 EDT 2014 | rob
Hi Emanuel, Chingyi do quite a wide selection of rubber tipped nozzles http://www.chingyi.com.sg/solutions_smt.php If you are in Europe, then Wilfred @ Europe-SMT knows these machines better than most: http://www.europe-smt.com/ Our personal favo
Electronics Forum | Thu Mar 17 05:24:15 EDT 2016 | robl
Hi Ermami, You can on the base Sapphire (non x or xii) - it's switches on the Connection Board, I'm guessing it's the same for the X & Xii, although they are pretty rare. It's in the Sapphire Service Manual, and also in the Topaz & Emerald X & Xi
Electronics Forum | Thu Jan 13 11:55:42 EST 2005 | fasst1
Rob, I also appreciate the banter. It is good to have these discussions with end users in a (hopefully) non sales environment. Philips actually started building Pick and Place machines in 1980 for high volume accounts. They started out because th
Electronics Forum | Tue Mar 27 11:05:33 EDT 2007 | Base
used Philips Emerald, Emerald-X or Emerald X2 if you want networking and an easy GUI. The first 2 are DOS-based, the latter one WinNT based. They take the Yamaha feeders, which are frequently offered on the equipment mart.
Electronics Forum | Mon Jul 05 12:09:37 EDT 2004 | modwyer
Folks, I have a Philips Topaz 1998 and Emerald 1999 that I am looking to get valued for possible sale. What value would you put on these machines?
Electronics Forum | Tue Oct 07 10:18:23 EDT 2014 | emanuel
Hi everyone, Any idea where can I purchase a nozzle for 3535 LEDs in general or Cree XPE specific, for a Philips Topaz/Emerald machine?
