Electronics Forum | Fri Oct 13 19:01:46 EDT 2023 | crystalw4280
I have an old Juki 2060 The electors were replaced on some heads that were disabled. Now we are showing some of the same errors with those heads. Does anyone have any suggestions for possible cause that would make this happen again. Another warning
Electronics Forum | Mon Apr 11 16:12:15 EDT 2022 | glasscake
MC Master has something similar but you pressurize the chamber with a nipple then have the unit disconnected from air.
Electronics Forum | Tue Apr 05 17:42:57 EDT 2022 | amchirsan
I am looking to replace some spray guns that I have been using for a few years that are no longer reliable. You can see them in the attached picture. Does anyone had a brand/model that they would recommend? Any info or advice would be greatly appreci
Electronics Forum | Thu Dec 18 21:36:03 EST 2003 | pdeuel
Blade angle, print speed, squeegee pressure, should be used in conjenction with one another. The more parellel the blade is to the stencel the more it will tend to float over the solder and the more paste is forced thru the appature. Contrary the gre
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
Electronics Forum | Mon Apr 01 09:30:41 EDT 2013 | dontfeedphils
Thanks for the reply, this is something that I am actually still fighting. I've been working with MPM directly since we ended up getting a service agreement, but I'm honestly not much closer to figuring it out today then I was when I first posted th
Electronics Forum | Wed Aug 26 18:36:17 EDT 2020 | serge_pirog
Hello. Could I ask you for help. We have DEK Europa. We have changed ProFlow to squeegee head with feedback. After this during solder paste printing system shows the difference between set pressure (9 kg) and real pressure (7,5kg). I have read manual
Electronics Forum | Fri Sep 21 17:35:46 EDT 2007 | valuems
the answer is very simple, it comes from 12 years of experience on the mpm's. And once you've done a calibration on the programmable print head, on a AP model you will know what I mean when I say it is not the easiest thing to do. harry
Electronics Forum | Thu Feb 17 17:33:34 EST 2022 | mnorthey
Hi all, I have a Dek 265 Horizon that fails to print at the correct pressure. It fails pressure every pass. I am trying to Calibrate it with a PFR1200N pressure Tester which we use for our DEK 248 Printers. I am trying to build up the table height
Electronics Forum | Thu Aug 12 22:31:10 EDT 1999 | Dave F
| Hello, | | Can any netters suggest what critical parameters should be considered & what are there assoicated impacts for a solder paste printing process ... | | B.Regards, | Felix | Felix: There are some 30 variables that affect SMT solder qua