Electronics Forum | Wed Feb 25 12:01:15 EST 2015 | jasonnova
Welcome to the world of Contract Manufacturing. Unfortunately there is not an opportunity for redesign. This is a growing customer that we are training to involve us during the design stage to avoid production issues like this. The customer would
Electronics Forum | Wed Feb 25 11:37:01 EST 2015 | jasonnova
We have a customer with an assembly that will require potting using 3M DP-270. There is a component that needs to be covered with potting material but it is considerably higher than the overall potting height of the cavity. The low viscosity of the
Electronics Forum | Mon Oct 14 18:27:38 EDT 2002 | kennyg
In regards to baking an assembly prior to hot air (BGA) rework.... 1) Do people always bake, sometimes or never? Does this depend on whether MS sensitive components are near the rework site? If a BGA is to be removed and reballed, baking is a no-br
Electronics Forum | Wed Jul 20 10:07:05 EDT 2005 | cecil
Does anyone have any input on the need to bake out an assembly prior to the conformal coat process? I understand baking out components/pwb's prior to processing through the reflow or wave solder process if the material shows excess moisture absorbtio
Electronics Forum | Tue Oct 15 10:12:44 EDT 2002 | davef
1) Do people always bake, sometimes or never? Does this depend on whether MS sensitive components are near the rework site? If a BGA is to be removed and reballed, baking is a no-brainer. Sometimes, based on the proximity of the MS components. >2)
Electronics Forum | Mon Dec 16 15:00:56 EST 2002 | sueph
We have always baked our assembled boards prior to wave solder, but have recently learned that there are some companies out there who don't. I checked with one of my supervisors, and he said that baking is recommended but not required. I'm wonderin
Electronics Forum | Mon Dec 16 15:10:56 EST 2002 | Randy Villeneuve
We do not bake any of our boards prior to wave solder. If we did we would have one heck of a large oven. I would assume you are concerned about moisture sensitive components. In most cases your top side parts should only get to 80 degrees centigarde
Electronics Forum | Wed Apr 19 11:50:05 EDT 2006 | amol_kane
Hi BJ, Everyone's favourite answer...it depends! If the volume if large, masking boots will save you both, time and money in the long run. Custom boots are relatively expensive to buy, but they pay themselves over time by savings on masking tape. ma
Electronics Forum | Wed Feb 25 11:47:09 EST 2015 | emeto
What are the chances for redesign the board or use substitute for the current tall part? Sometimes the hassle you want to go through could be avoided. How about change the box the device goes to or modify/ customize it to fit this part better in?
Electronics Forum | Thu Jul 21 08:24:28 EDT 2005 | dougs
are you going to clean the boards prior to coating?
Golden State is a contract manufacturer that makes wire harnesses, electromechanical assemblies (box builds, subassemblies, PCBAs, kits, etc.) and services (sorting, rework, value additive manufacturing engineering)
18220 Butterfield Blvd
Morgan Hill, CA USA
Phone: 5102268155
