Electronics Forum | Fri Mar 28 15:08:37 EDT 2008 | jmelson
Hello, all, I have been having problems with bent push rods on my Philips CSM84. I have caught it a couple times when it happened, but it happens so fast I still don't know exactly what the sequence is that causes this. The push rod is clipping a
Electronics Forum | Tue Aug 24 20:12:12 EDT 2010 | davef
What is a "SMD push fit connector?"
Electronics Forum | Thu Oct 08 16:42:05 EDT 2020 | babe7362000
Does anyone have Page 6 and 7 of the MPM SPM manual? I am currently having issues with low air pressure that pushes the table in. I get good air that pushes the table to the entrance, but I do not get good air pressure that pushes the table in. I
Electronics Forum | Thu Jul 20 12:16:26 EDT 2000 | Dave F
Bob: On "paste push-out" (when inserting a component lead into a through hole pushes the paste out of the hole) in pin & paste assembly: * What factors affect paste push-out? * What techniques reduce this effect, given a board design and component
Electronics Forum | Tue Apr 19 21:23:37 EDT 2022 | kumarb
Hi. On our YV88X (Emerald-X), we use the edge clamp + Push-IN clamp to secure the PCB. The push-in metal part pops up fine but unable to move this piece to the LEFT or RIGHT using the dial inside the machine. The latch inside the machine is rotated '
Electronics Forum | Wed May 29 04:34:36 EDT 2002 | Nell
Hi, Does anyone know about the epoxy push test specifications for the SMT chips component. For example: 0603, 0402 and 0201 chips. As usual, your help is very much appreciated. Thanks in advance, Nell
Electronics Forum | Wed May 29 10:14:04 EDT 2002 | Hussman69
You mean the destructive test were you continually push on a part until it breaks free from the board and flies across the room?
Electronics Forum | Tue Jun 06 16:50:33 EDT 2006 | pjc
Push Back !! Check out this article: http://www.circuitnet.com/web/article_20181.shtml
Electronics Forum | Fri Aug 21 11:00:48 EDT 2009 | boardhouse
Edoardo, if your going to try to push your book, why don't you disclose that the web site your pushing is yours. Boardhouse
Electronics Forum | Tue Aug 17 04:43:57 EDT 2010 | aj
Hi all, Just looking for some advice on SMD push fit connectors. Are most machines spec'd do place these reliably or do they cause problems? AJ...
