Electronics Forum | Wed Nov 27 18:10:41 EST 2002 | andrewbrook
Quad4C's have their moments. If the price is right and you are aware of the machines limitations then you will be satisfied. The placement rate is slow, 1.2 seconds/chip. Don't buy any Quad if it has the CyberOptics Laser unit, the Quadalign unit is
Electronics Forum | Wed Sep 04 09:47:41 EDT 2019 | smrsteve
Hello All, I've just bought a Quad 4c pick & place machine. It's so close to actually building boards, but just doesn't quite get there. I was wondering if there's somebody out there with experience of these machines that might be able to help...?
Electronics Forum | Wed Sep 04 13:58:36 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the response. 1. Function 30 gives me a consistent 182-185, even after nozzle changes. I can vary this by changing mod code 15 and I have been advised to aim for 90-110, but it doesn't seem to make any difference so I've go
Electronics Forum | Mon Mar 28 10:26:55 EDT 2011 | miroyu
Hello everyone . I received lot of help from people of this forum for which I want to say "thank you" guys. I had problem whit initialization of my Quad 4C which just sits for 2 years after purchase. I manage to locate problem with laser diode on pla
Electronics Forum | Wed Apr 11 00:40:19 EDT 2012 | ngineer
I have a problem setting up the LAE on my Quad 4c. I set it up for 0805, and it seems to work, although it rejects a lot of parts, at least it places "most" of them. I tried setting up on a soic14, and could not get even one to pass. I believe I h
Electronics Forum | Wed Sep 04 14:12:26 EDT 2019 | bobpan
It sounds like the vac-verify is not working. There is a command on the hht to turn it off. When turning off your hht will show either 'idle' or enter command' without the V showing anymore. Maybe try the cntrl and vacuum or shift and vacuum. If its
Electronics Forum | Wed Dec 23 22:34:22 EST 2020 | bobpan
Hello Marcelo, When you initialize the system in central controller...does it see mvs? Will a different job that you ran before work or does the same error happen? When do you see this error. You can email me at http://www.precision-repairs.com if y
Electronics Forum | Thu Dec 24 14:52:24 EST 2020 | bobpan
Good job, For the comm errors i would try: 1. Reseat all the cables that plug into the white multiplexer that is attached to the back of the computer. 2. Reseat the EPCU card down inside the machine. good luck, Merry Xmas, Bob
Electronics Forum | Thu Sep 05 07:14:16 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the suggestions. Sorry I didn't reply yesterday as I'd gone home - I'm in the UK, so I'm guessing there's a time difference. Okay, I found the control to turn off the vacuum verify - it's SHIFT - SWITCH/VERIFY. Makes no di
Electronics Forum | Wed Sep 04 12:01:59 EDT 2019 | slthomas
My recollection of the 4c is fuzzy but I know that there's a ribbon cable on the head that gets some abuse when the head rotates. Seems like mine would eventually break at the crimps and I had to replace it a few times. Eventually I bought the parts