Electronics Forum | Mon Feb 04 06:48:50 EST 2013 | bobpan
Do a function 30 on the hht and you should get a nozzle height of around 200. If its not and its around 1 you have something on the quad align lens and you will have the exact problem you are having. Hope this helps... Good luck
Electronics Forum | Sun Feb 10 15:14:25 EST 2013 | marcelorotofrance
After an in depth examination, I found that the problem was not a defective connector as I thought in the first place. Actually is a broken through-hole on the Quad Align sensor. I requested a spare part to PPM. Mr. Bobpan, thank you again.
Electronics Forum | Fri Feb 01 19:12:18 EST 2013 | marcelorotofrance
Hi, I have a QUAD 4C mk2. I taught pickups and places from HHT. If I test them individually (RUN STEP PICK/PLACE etc...) before building the sequence, everything runs ok. After the sequence was built, everything goes wrong. Every PICK or PLACE ends i
Electronics Forum | Mon Feb 04 08:04:39 EST 2013 | marcelorotofrance
Function 30 reads CENTER 1024 RUN OUT 0.0 with any nozzle and without nozzle at all. However I see that nozzle tip stops in front of laser beam. When I interrupt the beam with a piece of paper during Function 30, Z axis travels down until I take it
Electronics Forum | Tue Feb 05 19:00:18 EST 2013 | marcelorotofrance
I found problem, it was a faulty connector on the align processor card. So, Mr. Bobpan, I thank you very much for your invaluable guidance. P.S. My employer has been very clever and have purchased a 18 years old/ 25000 run hours/ third-hand equipmen
Electronics Forum | Mon Feb 04 11:01:44 EST 2013 | bobpan
The way its supposed to work...is....when you do a function 30 the z axis should step down until the nozzle tip is seen in the quad align or laser align. The readout should have a nozzle height but if its the earlier firmware for the machine it might
Electronics Forum | Thu Mar 26 10:42:16 EDT 2015 | bobpan
Glad that I can help.... Bob
Electronics Forum | Wed Jun 05 05:10:10 EDT 2013 | rollon65
Hi all. I already have a pair of Quad 4C Mk2 and purchased a Quad 4C Mk2 CE model secondhand. Some of the machine powers up but not the motor PCBs so the start up sequence stops after the nozzle changer operates with Motor Error #5 on the handheld.
Electronics Forum | Fri Dec 03 20:40:38 EST 2010 | olddog
We are a small company looking to purchase a used Quad 4c to bring some of our PCB fab in-house. In looking around at equipment we see both 4c and 4c mk2 versions of the Quad machine. Can someone please advise the difference between the two? Thank yo
Electronics Forum | Fri Oct 16 09:48:24 EDT 1998 | Jim Lewis
Help required on vision verify on Quad 4C/Mk2. In component editor, vision verify is OK. When linked into program, the following message occurs: "Bad or missing component description" Machine locks up. Can we get around this? If so how?
