Electronics Forum | Wed Aug 05 20:48:50 EDT 1998 | Ron Costa
I'm currently running a double sided paste smt board loaded with 0603's, on the secondary side. Many of the 0603 devices tombstone during reflow if the parts are not perfectly centered on the pads. Is this caused by the .008 foil thickness? Has anyon
Electronics Forum | Mon Feb 18 03:40:04 EST 2008 | akareti
Hi everybody, I found a defect varistor 0603 Tombstone and poor welting when we use component that terminal is Silver palladium (Ag/ Pd) with Leaded solder paste (63/37). Then we change alternative component that terminal is Ni/ Sn the result not fou
Electronics Forum | Thu Aug 06 12:16:52 EDT 1998 | Rin
| I'm currently running a double sided paste smt board loaded with 0603's, on the secondary side. Many of the 0603 devices tombstone during reflow if the parts are not perfectly centered on the pads. Is this caused by the .008 foil thickness? Has any
Electronics Forum | Fri Aug 07 10:14:43 EDT 1998 | RWW
| I'm currently running a double sided paste smt board loaded with 0603's, on the secondary side. Many of the 0603 devices tombstone during reflow if the parts are not perfectly centered on the pads. Is this caused by the .008 foil thickness? Has any
Electronics Forum | Thu Apr 24 23:04:45 EDT 2003 | yukim
I've been struggling with this problem for a while. We have two products: A, which is Ok and B, with tombstone defect (0603 & 0805 capacitor chips). A & B have the same design: pad sizes, separation between pads, components orientation. Both have s
Electronics Forum | Mon Aug 28 17:54:59 EDT 2000 | Steve Thomas
We're trying out 0603 packages on some 0805 footprints (at this stage only on some test boards) since our vendor tells us the 0805's are going to be getting harder to get, and more expensive to pay for. I understand the IPC footprint for the two is
Electronics Forum | Wed Apr 09 17:39:30 EDT 2008 | diesel_1t
Hi. I know that this is one of the mos common threads here, I have been doing some research, but i didn't find any similar. The main issue is that I have seen tombstoning since two weeks ago, it is more characteristic on 0603 resistors (Stackpole e
Electronics Forum | Mon Aug 16 11:58:29 EDT 2004 | Dreamsniper
I've worked with a Vapor Phase Oven a semi-automatic and a manual oven for evaluation. They worked fine and produce better grain of solder joints. The fluid that you need depends on the solder temperature that you require. I've used a 200'C fluid for
Electronics Forum | Thu Apr 19 21:49:29 EDT 2001 | davef
SCREENING... 1. Is type 4 paste necessarily required? [No, not unless you are using it for some other purpose.] 2. Is No-Clean Ok to use? [YES] 3. How thin stencil is required? 5 mils? [5 is OK, but I wouldn�t base the decision on the 0201. 6 mil is
winsouce.jpg)
.gif)
