Electronics Forum | Mon Sep 23 01:28:13 EDT 2019 | sssamw
Cannot understood your problem very clearly, please check IPC standard on QFN and its mfg process, also check the QFN supplier's recommendation, so can minimize the bridge.
Electronics Forum | Thu Mar 28 15:53:49 EDT 2019 | SMTA-Jon
As a CM, we don’t have a lot of input on the PCB layouts we receive. Some engineers/software packages output the paste layer 1 to 1, some do an across the board reduction, and some set each part up individually with different reductions per footprin
Electronics Forum | Mon Sep 23 10:45:34 EDT 2019 | slthomas
I have seen similar things happen with over etching and bridging but frankly the most common mistake that gives us grief is a failure to use the component manufacturer's recommended land pattern and/or aperture designs. As opposed to generating a n
Electronics Forum | Wed May 27 13:42:08 EDT 1998 | Chrys
| R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recommen
Electronics Forum | Wed May 27 14:35:52 EDT 1998 | Justin Medernach
| | R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recomm
| 1 |
