Electronics Forum | Tue Nov 27 03:39:49 EST 2018 | bukas
problem solved, it was corrupted system file.
Electronics Forum | Tue Nov 20 02:26:11 EST 2018 | bukas
hello everyone, I have this problem with one of my machines. it reports EMER error code: e804 "the scale of X axis can not be detected" has anyone encountered such error before? any idea what could cause it?
Electronics Forum | Fri Nov 23 11:41:27 EST 2018 | dalsenkenneth
Hello, bukas! Still experiencing the same thing until now?
Electronics Forum | Mon Nov 26 02:09:55 EST 2018 | bukas
yes I am, today im going to try to load backup image on to HDD. this error occurs before any machine movement, so it might be SW error... at least I hope so
Electronics Forum | Mon Jul 10 13:57:21 EDT 2023 | ttheis
We were able to get the machine to zero after 'scrubbing' the encoder head. We used a piece of paper towel and IPA and slipped it between the head and the scale. We moved it back and forth a few times to clean the head then blew out any remaining dus
Electronics Forum | Mon Jan 28 13:58:41 EST 2019 | oxygensmd
1. switch the axis cards 2. switch the axis servo cards 3. make sure the distance between scale and encoder is 400um 4. check the signal by oscilloscope, adjust to have the right signal 5. replace the scale or encoder
Electronics Forum | Tue Feb 07 20:43:59 EST 2017 | youngbuck
Does anyone know if there is a way around replacing the entire y axis tape measure scale for one scratch in it ,it can't read.Ive changed reader, y axis servo cards, taxis reader card.Any help would be appreciated.Thank you.
Electronics Forum | Thu Aug 04 09:40:12 EDT 2022 | jojoled
Hi, did anybody face such error(attached)? After calibrate all axis I get this error. "E202074 : Z axis of left head : SERVO alarm. Turn off the power to the machine and perform inspection" - see attachement. Machine was fully working day
Electronics Forum | Mon Jan 28 13:40:53 EST 2019 | liquidspacie
Hello, I'm trying to fix this error and what I've done so far I cleaned (no scratches) measuring scale and swapped cards (gantry 1 & 2) and cleaned scale reader sensor. There are no spare parts, I'm just trding to narrow down the cause. Any suggestio
Electronics Forum | Wed Feb 06 07:02:31 EST 2019 | liquidspacie
We've found the problem. It was fault scale encoder. Swapping cards didn't help. Thanks everyone for the input.
