Electronics Forum | Fri Feb 17 12:53:30 EST 2006 | bvdb
We just got our used Fuji IP-1 working well. Sometimes during testing of a new program/pcb we like to stop the run and re-start with a clean board. When we make the IP-1 eject the unfinished pcb and start with a new pcb the IP-1 does not scan the f
Electronics Forum | Wed Sep 22 22:21:31 EDT 1999 | JAX
| Hi All, | | We have 19 Siemens machine running here and lately I was assigned to come out with a proposal on the wrong part issue on Siemens Machines. All of our machines are equip with siemens part verification in which there the part barcode is
Electronics Forum | Wed Jun 29 19:33:12 EDT 2005 | matjen
After the machine stops for any reason when restarted the z table goes to loader position comes up then goes back down and re-reads the fiducials, only one machine does this but we are losing valuable cycle time after every part change. We have Fuji
Electronics Forum | Tue Oct 26 00:03:09 EDT 2010 | jmelson
Hmm, that's a fairly old machine, even older than mine! (I have a CSM84 PA130640). Anyway, it is best to program the machine from CAD system data, I wrote a little program in C to read in the component type and XYR position, and produce the file in
Electronics Forum | Tue Jul 29 03:10:18 EDT 2008 | tpradio
I have a problem with a I-pulse M1. Monday morning i came back from vecation, and started up the machines. warmed them up, and then..... When i started the program, (normaly it starts with scaning the nozzles) the head moves to the first nozzle, and
Electronics Forum | Fri Sep 24 06:38:15 EDT 1999 | pgarsoe
| | Hi All, | | | | We have 19 Siemens machine running here and lately I was assigned to come out with a proposal on the wrong part issue on Siemens Machines. All of our machines are equip with siemens part verification in which there the part barco
Electronics Forum | Wed Sep 30 06:22:23 EDT 2015 | mervin
MPMENG, Thank you so much for taking the time to help. The machine has Y snuggers and flippers. The Pcb is loading in the center all the time. The driver cards look fine there is no obvious faults on them or partially burned. The machine was not in
Electronics Forum | Thu Dec 29 10:14:27 EST 2011 | davef
Darpy's offset checking trick: One trick I always use is to make the first two placements in every program the same as the fiducial data picked up from a dummy feeder. These two placements are generally skipped. ** If I do have a problem then I unski
Electronics Forum | Wed Jun 19 07:24:10 EDT 2013 | bobpan
Hello Rollon, There needs to be a contrast between the sticker and board. The manual gives and example of a round red sticker. If you still cant still make this work.....Do the following. Run the machine and after it finds fiducials press stop on the
Electronics Forum | Fri Mar 29 16:57:07 EDT 2013 | aemery
Gentlemen, Just became a member and scanning the old posts hoping to help people out with their MPM printers. Most of this info is correct, the last post was the best. Offsets on an Accuflex printer can be put in either per process program or glob
.gif)
