Electronics Forum | Fri Dec 27 17:40:55 EST 2019 | rgduval
Using no-clean flux will make the boards very difficult to clean. If you can switch to water soluble flux, your life will be much easier. The "icicles" lead me to think that the board isn't getting hot enough in the pre-heat cycle, and/or there isn
Electronics Forum | Wed Feb 19 12:59:59 EST 2020 | jerlong2020
Hi John, We had a FLIR system with interchangeable lenses and good thermal resolution for the time (15 years ago). I see the new ones now at a fraction of the cost which we paid and they have better resolution. Amazing how the infrared imaging tech
Electronics Forum | Mon Mar 09 14:16:37 EDT 2020 | oxygensmd
I used to work with S15/F3, was a 10 years ago. 1. Test your machine controllers and station controllers. Load the last program with actuell command. 2. You can check what happening in the SiPlace, switch the monitor to MC, let see all bootup perfec
Electronics Forum | Mon Mar 09 16:22:05 EDT 2020 | sportsradar
Hello Kristof, We use 1 PC which does line control and programming. We always boot the PC up first, then when it is fully booted, then we turn the machine on, we let it zero set, then we send the job over (this is how we do it when everything works)
Electronics Forum | Tue May 05 06:50:14 EDT 2020 | greezmky
I am having an issue with our CP-642. It will place fine a great deal of the time however when there is a feeder issue or if the cycle changes, after a part is replenished, it will suddenly miss RS1A diodes on the boards for about five to ten boards
Electronics Forum | Tue Jun 23 13:50:05 EDT 2020 | dltechltd
505.05 SP2 Hotfix3 After this, we were able to work with the machine until 1 week and the machine broke again. A small zener diode exploded on a Servo card, and we replaced it. Next reboot, the MC system halted, because an SRBS error. We have aske
Electronics Forum | Tue Jun 23 22:19:33 EDT 2020 | kumarb
Hi. Have an older 1809EXL that was purchased new and has sat idle for years with 270 on hours as of today. After days of testing, unable to melt fresh paste from Loctite (SAC305). The root cause after the investigation is due to one of the 2 TDM modu
Electronics Forum | Wed Jul 22 07:51:28 EDT 2020 | spoiltforchoice
> I would have thought the other way. We are > currently using 2 CP642s for high volume and they > are doing an excellent job. Electronic feeders > are too expensive and we don't see any benefit > for that expense. I imagine it
Electronics Forum | Thu Jul 23 13:23:45 EDT 2020 | bmalhi
Small components blown issue could be due to one of the below. - Process issue; Make sure solder paste is fresh, if flux is drying out it will not hold parts properly. Check downward pressure of Pick Place. SOT may have to be pushed a little harder i
Electronics Forum | Tue Sep 08 13:12:05 EDT 2020 | spoiltforchoice
> Tombstone is often caused by an imbalance of > temperature, pad shape or spacing, component > termination, and component positioning. Pate > formulation and reflow atmosphere are other > common causes. Looking at the pads and &