Electronics Forum | Mon Jan 14 02:22:51 EST 2008 | ilona
David, why not contact the current suppliers of selective soldering systems for a copy of their layout specs? Surely we all would be interested to provide potential customers with the info they need to evaluate a process applicabilty or to design bo
Electronics Forum | Tue Nov 14 21:55:54 EST 2000 | Dave F
There's a boat load of causes for icicles. Favorites are: * Conveyor speed too high * Conveyor angle too high * Contaminated solder
Electronics Forum | Thu Jan 14 06:03:51 EST 2021 | manaik
Hello, We have recently bought ZipaTec select 250, we are having problems with offsets. Somehow the offset of fluxer, wave and preheat dont match one another or the program we create. The previous owners are of no help. The main question i have
Electronics Forum | Wed Jul 27 18:41:48 EDT 2005 | crishan
Aj, You are correct, we use pallets to hold the motherboard, an X-Y table then transports the pallet through preheat section to the solder bath. I will check out your recommendations on the solder alloy. Supplier is not willing to share PPM data o
Electronics Forum | Wed Jul 26 09:14:47 EDT 2000 | Peter J. Lensch
Hi DT, there is a pallet type system available from ERSA. Please contact ERSA Inc in Wisconsin, Bob Klenke, phone number 262 375 6844. PJLensch ERSA GmbH in Wertheim
Electronics Forum | Sun Jan 10 19:51:20 EST 1999 | Chris G.
| I need leads on equipment vendors for selective soldering systems. I have information about ERSA and Seho already. I want to contact Air Vac in particular, but I can't find thier phone number. Thanks for the help | Jim, Below are a couple of
Electronics Forum | Fri Aug 02 11:48:23 EDT 2002 | johnw
I can't think of any off hand other than the Ersa which is massive and from when I used it a pain in the A*SE to program and keep programmed, you always seem to have to baby sit it. I bet if you asked you could get one, the problem is that forced con
Electronics Forum | Mon Jul 08 13:10:55 EDT 2013 | rgduval
As with any issue like this, your miileage may vary with suggestions....but, here are the items I would consider: 1. Clinch tightness. I believe IPC gives a recommendation on the amount of bend in a clinched lead; make sure you're not beyond that.
Electronics Forum | Tue Jan 12 00:16:15 EST 1999 | Jason Nipper
| | I need leads on equipment vendors for selective soldering systems. I have information about ERSA and Seho already. I want to contact Air Vac in particular, but I can't find thier phone number. Thanks for the help | | | Jim, | | Below are a
Electronics Forum | Thu Jun 22 13:01:23 EDT 2000 | DTRoxell
I am looking for anyone who uses the ERSA Select Solder machine with pallets. Does anyone know if you can run pallets with this machine?