Electronics Forum | Mon Apr 29 12:32:18 EDT 2013 | stephendo
Do you watch when it is doing the wave height test? Watch it and see if it goes up to the same spot on the test probe each time. If the test probe is dirty sometimes the solder has to go up higher on it before it gets detected. You might actually be
Electronics Forum | Thu Apr 25 09:57:31 EDT 2013 | jaimebc
We aquired an ERSA ECOSELECT 2 selective soldering machine. So we are going through a learning curve and I would like to hear from ERSA users on this subject. The main concern is to keep the miniwave steady, it seems that it " bounces" a lot and is
Electronics Forum | Thu May 02 14:58:20 EDT 2013 | stephendo
Kurtz had a guy that was great with the machine. I strongly suggest that you watch the wave height test a few times in the morning then at lunch and at the end of the day. Look where the solder goes up to on the probe. If it doesn't work consistent
Electronics Forum | Mon Aug 21 10:52:23 EDT 2000 | Ron H
Problem: Flux remains on the board in the masked areas after the wave solder process. We use Multicore X32-10m no clean flux. There is no post wave cleaning. While the flux residue is not conductive, it is unsightly and it may interfere with a be
Electronics Forum | Mon Apr 29 13:56:19 EDT 2013 | williamaxler
We have a Versaflow 40/50 and ours is setup like this. We have out nozzle test position set so that in the Z axis you are 3.8mm away from the pin. Used feeler gauge Then you can set your gradient per nozzle. Start with a number then do a wave offs
Electronics Forum | Thu Nov 14 10:24:53 EST 2013 | jaimebc
Recently, we have been experimenting with the 1.8/2.5 nozzle to be able to solder leads that are near an SMD. This pcbs were not design for selective solder, so we are trying to work within this limitations. I found the 1.8 nozzle very hard to insta
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
Electronics Forum | Wed Aug 29 13:43:27 EDT 2012 | icin
Thanks to all of you that have replied and those that may eventually reply. We are feeling better now that you experts with many years of experience have not indicated that this is as common as ESD or Moisture Sensitivity Awareness to the point that
Electronics Forum | Fri Feb 17 18:33:08 EST 2006 | mika
Paste In Hole "PIH" or Pin In Paste "PIP" are two different names of the same process. As far as I know this is fairly simple: the reason from the beginning is to avoid an extra process step/steps in the production line. That is to produce through h
Electronics Forum | Fri Feb 16 09:30:38 EST 2007 | DEK Answer Guy
Hello PR, PumpPrint� technologies enable high throughput adhesive deposition using a screen printing platform. Careful selection of stencil material, and informed study of the design of apertures and other stencil features, enables a wide range of