Electronics Forum | Thu Jun 06 10:11:06 EDT 2013 | eniac
azhiker, for me I selected method A. But I don't turn off wave and apply acid directly to nozzle with solder.
Electronics Forum | Thu Jan 10 22:55:24 EST 2002 | davef
You are sure taking you sweet time getting this thing running. You're getting too much beach time. NOZZLE SELECTION Typically, the only rule of thumb that applies to choosing the correct nozzle ID is that it should be one half of the required dot d
Electronics Forum | Thu Jul 07 14:58:18 EDT 2011 | vickt
Prasad, It is typical when experimenting with new materials to have to adjust the airpressure on the syringe and the stroke of the PDP piston (screw adjust on top of the PDP pump). You can add mutiple cycles in the comp Db to make larger dots with th
Electronics Forum | Tue Sep 15 14:11:59 EDT 2015 | jpal
You should also remove all the pump parts and clean them, checking the bearings and seals. Clean completely the parts that allow the solder to flow back into the pot; ours have a spiral that fills with dross. Treat yourself to new nozzles. Tinning
Electronics Forum | Sat Mar 30 17:27:45 EST 2002 | davef
You should not have glue "all over the place." Tou should not have glue on solderable surfaces. It sounds like you are stringing glue from one dispense location to the next. Search the fine SMTnet Archives [there might be something there]. Read a
Electronics Forum | Tue Apr 05 08:37:16 EDT 2016 | duoman
I'm normally running 8 hours a day M-F, and an infrequent Saturday. My nozzles are from Pentagon EMS.
Electronics Forum | Wed Feb 22 09:35:35 EST 2023 | richardcargill
out of interest, do you know what the nozzles are made of ? If you could get titanium ones then i would have thought abrasive wear shouldn't be an issue
Electronics Forum | Thu Mar 02 20:39:42 EST 2023 | markhoch
If you're using a good quality nozzle, you can clean the oxidation off with a wire brush and an emery cloth. Just make sure you re-tin it very well before you use it.
Electronics Forum | Fri Feb 17 17:41:23 EST 2023 | SMTA-71549289
We have a legacy Pillarhouse Jade and am not sure how long we can expect a nozzle to last. We're new to using selective solder and we have things going, but there are some details like this where we just don't know what a reasonable expectation can b
Electronics Forum | Mon May 11 02:19:06 EDT 2009 | malmsteen
Hi PCB experts, I am tasked to design boards (medical) that can stand -90 Deg C environment. I am seeking for help from all the PCb experts out there in guiding me on the right selection of PCB materials, soldering alloy (SMT & Wave) and right comp
