Electronics Forum | Wed Jul 12 17:17:04 EDT 2006 | fordf1502004
I want to thank you for your help. after further investigation into the panasonic machine one our technicians was able to fix the issue. The panasonic machine uses a 5 volt signal and normal smema uses a 24 volt signal. To make these 2 machine talk t
Electronics Forum | Tue Dec 07 09:32:32 EST 2004 | pr
http://www.jotautomation.com
Electronics Forum | Wed Apr 21 14:38:30 EDT 2010 | remullis
Newer Universal Conveyors use 4 wire smema and FUJI should accomodate this protocol in its config screens. Old Universal Conveyors and some machines used SMPI (forget how many wires), You can purchase the 4 wire smema cable from UIC and conversio
Electronics Forum | Tue Dec 07 00:13:00 EST 2004 | saiwong
I have a problem that our JOT convoyors & loader cannot connect the Fuji machine. Also, I wondered how can I get the support from JOT.
Electronics Forum | Wed Sep 07 07:53:16 EDT 2016 | ttheis
Looks like I've got to reconfigure the fmi connections. Only pins 1 & 2 populated and when I jump the fownline pins the upline ready signal is activated. I'll reference the diagram and setup the connections for smema.
Electronics Forum | Wed Aug 31 09:45:36 EDT 2016 | ttheis
I have a smema conveyor connected to the downline fmi connection on my up500 but the fmi sugnals show the coneyor ready signal going ro the upline ready input (screenshot). The downline ready output is activated qhen a board is output from the printe
Electronics Forum | Wed Sep 07 16:36:18 EDT 2016 | ttheis
It does look like it was setup for fuji or siemens connection. I did get the smema signals working; had to add the connections for pins 3 & 4 on both ports and move some of the existing connections according to the smema diagram. Also, I wasn't seein
Electronics Forum | Wed Aug 31 17:12:23 EDT 2016 | ttheis
Yeah, it's set to use SMEMA for down line. I have the conveyor conected to downline fmi on up500 (right side of machine,) but the Upline Ready light is activated on the up500 when the conveyor is ready and not the downline like I would expect to see.
Electronics Forum | Mon Apr 11 13:11:30 EDT 2016 | gbkellyk
Hi, I hope someone is able help me I have just purchased a used ASYS LSB03 bare board loader and when I have switched the unit on the display reads MODUL 02 OFF also the control panel is frozen and does not respond to any of the buttons when pressed.
Electronics Forum | Thu Jun 14 08:30:53 EDT 2007 | pavel_murtishev
This solution is not as complicated as you might have thought. T-conveyor connected machines are widely used for applications requiring high material deposition throughput. This solution is made of: 1. Two independent screen printers 2. Two line loa
