Electronics Forum | Fri Jun 23 11:27:27 EDT 2000 | Super K
Chrys and C.K. (or Little K from what I'm told), Where "I" work at, our fine management staff has informed us of "Smart Solder"! Not sure who makes it, but they claim it will make all your soldering problems go away. I'll send ya more info on it
Electronics Forum | Sun Jun 04 08:49:58 EDT 2000 | Roni Haviv
Hi C.K. , You can ask your PCB manufacturer to cover all vias with solder mask from CS (It called "pluged" vias). It's done from one side to prevent any close area that can cause "eraption" of solder because of pressure under reflow. All our boards
Electronics Forum | Thu Jun 01 21:59:10 EDT 2000 | Ray Chartrand
Does anyone know the current cost to repair a defective solder joint? I seem to recall a number quoted a few years ago of $1.03 per joint with burden of overhead. I've also seen numbers from 50 cents to 50 dollars per joint.
Electronics Forum | Thu Jun 01 10:48:21 EDT 2000 | Jeremy
I am having a problem with the green solder mask flaking off exposing bare copper. The mask was defective from the board manufacturer. My problem is the boards are already assembled and we are just finding the problem. Is there a standard that cover
Electronics Forum | Thu May 25 11:51:12 EDT 2000 | AF Ng
Hi,Wolfgang Busko, Thank you for your help. Still need some advice. If the OSP board having stencil rest on the solder mask, then, would it has more gasketing effect( solder paste squeezed out to the underside of the stencil), as compared to the HAS
Electronics Forum | Tue May 23 22:23:20 EDT 2000 | JAK
Hi all, I'm would like to try intrusive reflow (pin in paste, paste in hole, etc.) on a connector using WS-609 solder paste (halide free, water-washable). I'm concerned about entrapped flux in the barrel of the solder joints. If there were to be e
Electronics Forum | Tue May 23 22:21:13 EDT 2000 | JAK
Hi all, I'm would like to try intrusive reflow (pin in paste, paste in hole, etc.) on a connector using WS-609 solder paste (halide free, water-washable). I'm concerned about entrapped flux in the barrel of the solder joints. If there were to be e
Electronics Forum | Wed May 10 22:53:18 EDT 2000 | Tan Kheng Beng
The Cpk collected by placement on glass boards and calibration has been done. All has been fine until we actually try on actual boards with printing. We have problems like insufficient solder due to closed aperture, improper flow of solder on the pad
Electronics Forum | Thu May 04 10:35:24 EDT 2000 | Sal
THE TERMINONOLY I USED SEEMS TO BE INCORRECT , I THINK THE TERM I WAS LOOKING FOR IS WICKING . BACK TO THE PROBLEM , ISSUES WITH RESNETS, WHERE THE SOLDER PASTE SEEMS TO BE WICKING AWAY FROM THE TERMINATIONS OF THE COMPONENT TOWARDS THE VIAS WHICH AR
Electronics Forum | Fri Apr 28 15:55:39 EDT 2000 | J. G.
I am looking for a company that buys and recycles scrap boards. I talked to some company at NEPCON last year that recycles boards but have since lost their name. I am wondering what people do with thier scrap boards and solder sample boards. Due to t