Electronics Forum | Wed Oct 21 13:50:50 EDT 2020 | kierantennant
hi, I am experiencing a problem with our wave solder machine where zone 2 (forced convection) fan will not work when called upon. so we swapped it with zone 3 to make sure the motor was not at fault and it wasn't so we moved the A1 into a different 2
Electronics Forum | Fri Jun 15 12:07:13 EDT 2018 | fern
My company is hooking up a delta max wave solder machine but we can seem to get the estop error to go away any one have a any experience with this issue.
Electronics Forum | Thu Jun 25 09:52:06 EDT 2015 | byviko
Hello, we will buy new wave soldering machine . Trying to decide between two model; Soltec Delta-x and ERSA Powerflow N2. Could you help us , which one is better? most of pcb low volume, others high volume. At first low batch production will be done
Electronics Forum | Mon Jun 29 07:17:25 EDT 2015 | donlockard
Seho maxi wave 3240 should be considered as well. Invented full tunnel nitrogen systems that have lower operating costs and provide yields unlike what can be achieved by air wave systems.
Electronics Forum | Thu May 28 01:48:16 EDT 1998 | Roni Haviv
Hello, I need some users information about "hot air knife" after the wave bath: - Defects reduction ? - In what kind of boards(TH/SMT SOICS ect.) it is applied ? - Where can I purchase it as a retrofit (Soltec Delta 6622cc) ?
Electronics Forum | Thu May 28 09:23:59 EDT 1998 | Chrys
| Hello, | | I need some users information about "hot air knife" after the wave | bath: | - Defects reduction ? | - In what kind of boards(TH/SMT SOICS ect.) it is applied ? | - Where can I purchase it as a retrofit (Soltec Delta 6622cc) ? |
Electronics Forum | Thu May 28 12:47:08 EDT 1998 | Dave F
| Hello, | | I need some users information about "hot air knife" after the wave | bath: | - Defects reduction ? | - In what kind of boards(TH/SMT SOICS ect.) it is applied ? | - Where can I purchase it as a retrofit (Soltec Delta 6622cc) ? |
Electronics Forum | Mon May 21 17:56:04 EDT 2007 | mefloump
We have a Delta Max (leaded) and a delta wave (lead free) and a soltec Selective solder. The software that runs the selective solder is much different than that of the wave machines. We have fitted our selective with a leaded and lead free pot to han
Electronics Forum | Fri Feb 22 13:19:54 EST 2013 | caurbach
Our new Soltec Delta 3 has this feature (they call it mainwave pushup) where you can add up to 60 rpm to the pump after the leading edge passes over the wave. Unfortunately, our old Delta Wave doesn't have this feature. Ideally we'd like to set it
Electronics Forum | Wed Sep 20 17:06:23 EDT 2000 | jackofalltrades
On the Vitronics/Soltec Wave Soldering Machines, we have no problems with the hot air knife (called a "Select X De-Bridging Tool" by Vitronics). We have both Delta's and Delta Max's. We have used both air and nitrogen with no problems. When using a "
