Electronics Forum | Wed Feb 22 12:40:41 EST 2006 | russ
Here are some of the things we had to do when we had to validate process. Incoming voltage Air pressure squeegee speed placement accuracy oven stability
Electronics Forum | Fri Feb 23 19:27:04 EST 2007 | greg york
true in the olden days, new osp's have excellent thermal stability. they are thinned or removed by organic acids mainly. contrary to believe due to the higher tin content they do tend to work well with lead free better than leaded used to. cheers gre
Electronics Forum | Tue Sep 23 18:55:59 EDT 2008 | smt_guy
"Ionization of the air causes an increase in conductivity..." I have an Ionograph and everytime I open the test lid cover the Baseline Stabilization Resistivity Value s by 60M Ohm-cm. My question is: Is there something to worry about our facilities
Electronics Forum | Mon Feb 09 19:15:11 EST 2009 | dlocampo
Viscom is still there if in case you want to try the algorithms, we are already using them for almost 3 years now and the inspection stability and detection consistency are excellent.
Electronics Forum | Thu Dec 08 09:54:53 EST 2011 | dyoungquist
Since it is listed as "Typical Run Current", my assumption is that is the current after it has heated up and stabilized at your profile settings, i.e. not start up. The recommended breaker size is 100 Amps. That would imply it can draw more than th
Electronics Forum | Wed May 15 11:13:36 EDT 2013 | pavel_murtishev
Davef, Could you tell me if you filled your floor by additional concrete layer during your shop construction? Have you had any placement machines stability issues? Your input would be really valuable. Thank you.
Electronics Forum | Wed May 15 05:31:53 EDT 2013 | jlawson
Also make sure nozzle retraction is ok, if nozzle shafts stick at different heights can effect laser centering stability.
Electronics Forum | Thu Nov 13 21:50:28 EST 2014 | warwolf
AH! nice one, I didn't consider glass marbles. I'm curious though, how did this affect your heating/thermal stability? Did the marbles ever float?
Electronics Forum | Fri Sep 02 04:18:48 EDT 2016 | bukas
i have tested voltages on Processor board X12. all voltages are ok and stabil but +VPP (PT8 - TP9), it reads 0 volts
Electronics Forum | Tue Jan 09 15:26:49 EST 2018 | emeto
The truth is that TH will give you better mechanical stability. If it is a part where you risk strip off the pads of SMT connector, don't make this transition to SMT. If it is a one time cable plug there and there will be not too much pressure, go fo
