Electronics Forum | Thu Oct 30 09:15:20 EDT 2008 | kingshar
Hi, Hi, 1) Can anyone tell be what is the acceptable manufacturing tolerance from stencil to PCB . 2) what are the methods we can avoid that. 3) What is the method to avoid PCB shrinkage. 4) How can we correct shrinkage 5)Is there any standard gud
Electronics Forum | Fri Oct 31 08:02:14 EDT 2008 | davef
Here is some more reading on stencils for you: http://www.smtinfo.net/Db/_Stencil%20Printing.html
Electronics Forum | Fri Oct 31 07:15:39 EDT 2008 | kingshar
Hi Andrzej, Thank you for your suggestions. The Link which you referred is really informative. Thanks and Regards, Kingshar
Electronics Forum | Fri Oct 31 06:55:35 EDT 2008 | andrzej
Answer on point 2 - I understand you send him gerbers of single PCB (?). In most cases you have panelized PCBs so to avoid problems with stencil first you should order PCBs and ASK your PCB supplier to send you back his gerbers of panel. There are so
Electronics Forum | Mon May 07 16:07:05 EDT 2012 | davef
Start with targets based on the stencil thickness (for height) and stencil thickness times the aperture size (for volume). * Set reasonable upper and lower control limits (+ 25% and –25 % of the targets, for example). * Next, check the printer set-u
Electronics Forum | Thu Dec 07 13:51:59 EST 2006 | ganoi
I need advices as to how a gap between the bottom of an LED (1209-package) and the PCB can be controlled on a small rigid-flex PCBA? The problem that we experience is due to tight tolerance in the design of our molded housing in which this PCBA is as
Electronics Forum | Thu Dec 07 19:20:28 EST 2006 | ganoi
Most likely there is movement during reflow. How about conduction oven over convection oven for reflow? This is a small PCB with the LED sitting on a Flex-Rigid extension from the PCB. I was thinking if the stencil aperature for the LED was to be cu
Electronics Forum | Thu Jul 06 21:24:10 EDT 2017 | heros_electronics
Hi Jack, Haven't you done 100% E-test? there is a registration tolerance. CCD+/-2mil, Manual+/-4mils according to our manufacturing capacitites.
Electronics Forum | Wed Dec 07 17:43:31 EST 2011 | mikenil
Hi I do not work for a board house but a manufacturing facility where we do a considerable amount of soldering wires to through holes. We pretin our through holes on both sides of the PCB prior to reflowing the solder and installing the conductor (w
Electronics Forum | Mon May 02 12:35:33 EDT 2016 | adamjs
Or try : http://www.sipad.com/ I think sipad is incredibly cool and would be the perfect solution, but is way too expensive. We're paying $0.80/each for four-layer ENIG boards, 50cm^2 with 0.125mm trace/space and 0.8mm-pitch LGA landings in lots of
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
winsouce.jpg)