Electronics Forum | Fri Feb 04 15:14:19 EST 2000 | JDobos
Would like to make discuss the nature of MEM's style packaging with someone with experience in this area.
Electronics Forum | Mon Feb 29 11:58:41 EST 2016 | dustin
When looking at 0402 parts in our old style Europlacer trolleys, the pick up point is in between two part slots. I have heard that there is a manual adjust somewhere on the sides of the trolley that will let you move part into the pick up window. I h
Electronics Forum | Wed Mar 02 08:58:48 EST 2016 | mbass
From what I can rememeber I used to set x & y to zero advance the tap ethen it was press the lane and vaild button together to advance half a pitch which should bring it all into line. All the older RC software you could just put a manual adjustment
Electronics Forum | Mon Apr 05 21:46:12 EDT 2010 | isd_jwendell
I have been using this series with AIM SnPb no-clean paste without problems.
Electronics Forum | Mon Apr 05 22:52:40 EDT 2010 | davef
Sounds like you're not getting the solder connection hot enough. Talk about: * Temperature of the solder on the connection * Solder alloy * Board solderability protection * Component solderability protection
Electronics Forum | Mon Apr 05 16:12:16 EDT 2010 | dyoungquist
We are installing via reflow soldering a crystal that has 2 pads, 1 each end. They are flat pads on the bottom of the part with a small area of the pad looping around and up the side of the crystal on the end. Inspection of the cyrstal under a 40X
Electronics Forum | Thu Jun 08 09:26:26 EDT 2023 | frankchan
placement> (curing)> reflow soldering> cleaning> inspection> rework SMT production process Surface mount process a. Single-sided assembly: (All surface-mount components are on one side of the PCB) Incoming inspection-solder paste stirring-screen prin
Electronics Forum | Tue Mar 16 17:14:05 EST 1999 | Matt Dussling
Looking for a company that makes a small batch reflow oven. Not a belt-style convection oven, but a cabinet style that can 125 c to 150 c. Thank you
Electronics Forum | Wed Oct 22 16:44:51 EDT 2003 | dave
Hi, I was wondering what are the differences between a "trailing edge" style squeegee and a "diamond section" edge style. What applications tend to favor one over the other? Thanks. We are using a DEK 265
Electronics Forum | Mon Mar 06 22:06:15 EST 2006 | kent_peterson
Same for fujiflexa or cam. Just make sure the one you get has new style shafts. I doubt you can get the old style and to switch takes doing all shafts.
winsouce.jpg)
