Electronics Forum | Fri Oct 16 11:32:03 EDT 2015 | azdback
What is your error code?
Electronics Forum | Wed Sep 16 14:04:33 EDT 2015 | adventurelights
Hi guys, Recently got an error message when initiating hardware on a Mydata TP9-UFP. Message is: Theta/2: Lower end point not repeatable. Reinitiating fails at message. Haven't seen this message before. Any idea what it could be as production is hal
Electronics Forum | Sat Sep 26 00:53:54 EDT 2015 | padawanlinuxero
Hi guys, > > Recently got an error message when > initiating hardware on a Mydata TP9-UFP. Message > is: Theta/2: Lower end point not repeatable. > Reinitiating fails at message. Haven't seen this > message before. Any idea what it could be as
Electronics Forum | Tue Nov 27 09:46:40 EST 2012 | jaimebc
Interesting, it seems the theta error followed the ZFIB board, running the machine with the original theta error and using the ZFIB board from the second machine since Thursday, no errors since...will continue to evaluate and post results...
Electronics Forum | Mon Nov 19 17:43:16 EST 2012 | jaimebc
Theta error came back again during our first production run. Swaped motcards as a final attempt to find an easy fix and nothing. I swapped heads with another MYDATA to positively isolate the problem. And the theta error followed the head.
Electronics Forum | Tue Nov 20 13:15:56 EST 2012 | bk
Well before you totally give up on the midas head, you may wanna try changing out the ffx board/cable on it to make sure the one in there isn't binding once in a while and giving you your theta errors.
Electronics Forum | Thu Dec 06 14:45:50 EST 2012 | jaimebc
New ZFIB board installed today. Running ok, theta error has not appeared yet. Will post updates as we continue to evaluate.
Electronics Forum | Tue Dec 18 21:47:14 EST 2012 | jaimebc
So just to update and close this thread, it was the ZFIB board ( the one mounted on top of the theta motor) that was causing the theta motor to error out) Problem fixed. $ 30 dls or so from MYDATA. Hope this helps some one down the road.
Electronics Forum | Tue Nov 13 11:14:15 EST 2012 | jaimebc
For the past few weeks we have experienced an intermitent midas theta error.During normal production the machine times out while just after picking up a component waiting for the theta to center it.Sometimes it fails to leave a tool. Reinitianing the