Electronics Forum | Thu Jan 31 16:29:26 EST 2013 | markhoch
I had the exact same issue a few years ago at my last place of employment. It happened twice within two months on two seperate peices of Crown-Simplimatic Equipment. I immediately sorced and replaced every lithium battery in all of my Loaders, Unload
Electronics Forum | Wed Mar 21 21:24:12 EDT 2018 | neoplymike
hello MEKO Tech, thanks for your introduction. I had an experience for buying universal stylus from MEKO Tech. I still remember that that is a really nice experience. These products I bought from them are of good use to me. I like them very much and
Electronics Forum | Tue Oct 31 13:15:13 EST 2006 | realchunks
SWAG is prolly right. You can verify the tactile sensor by watching the machine carefully. When finding the stencil height, make sure the board goes all the way up and touches the stencil to trigger the tactile. If it doesn't, then something is wr
Electronics Forum | Thu Apr 19 21:49:29 EDT 2001 | davef
SCREENING... 1. Is type 4 paste necessarily required? [No, not unless you are using it for some other purpose.] 2. Is No-Clean Ok to use? [YES] 3. How thin stencil is required? 5 mils? [5 is OK, but I wouldn�t base the decision on the 0201. 6 mil is
Electronics Forum | Thu Sep 09 13:31:26 EDT 1999 | Brian W.
| | My company is looking to perform "real time" statistical process control on our current SMT operations. I have identified the critical processes for SPC but have not had much luck in finding a system(s) that can monitor the required processes for
Electronics Forum | Thu Apr 19 11:04:43 EDT 2001 | Spanky
All, We are getting ready to start running with 0201 passives. I have never run these before. We have run some 0402s however. We don't have any assemblies in-house yet, so I can't give any intelligent information regarding the board design (size,
Electronics Forum | Sat Mar 06 08:19:50 EST 1999 | Dave F
| Clarissa, | | Dave had good suggestions. We load several boards manual at this time. We set our components up in clearly marked bins. The documentation includes a chart with the part number, bin number, reference designator and color code for t
Electronics Forum | Fri Dec 09 15:10:55 EST 2011 | davef
Can you use the equipment manual as the basis for learning how to use the machine? Each model of printer has different alignment techniques. We don't have a clue of your model type. So, we'll approach the question from its most basic point. Registe
Electronics Forum | Wed Jun 27 22:03:48 EDT 2012 | davef
Here's some notes I've collected over the years on the topic ... Small MRP * I havent used it [DBA Manufacturing] yet but I do find myself keep coming back to it - I have been searching for a decent ERP system for my micro company for years. What I
Electronics Forum | Tue Nov 08 10:52:29 EST 2016 | aemery
Tom, Hardware limit means the machine thinks it is at the limit sensor or a particular axis timed out before it got to the home sensor during the reset sequence. Go to your O/I map and see if any of the axis limit sensors are lit. You could have a