Electronics Forum | Sun Apr 25 12:05:50 EDT 1999 | Chrys Shea
| | | Has anyone had trouble waving and gluing 0603 R's and C's? At my company, our designers have "opened the floodgates" on bottom-side 0603's. | | | | | | We've got an EPK+ with rotary chip and omega wave but can't seem to get skip-free solderin
Electronics Forum | Mon Apr 26 09:18:27 EDT 1999 | C.K.
| | | | Has anyone had trouble waving and gluing 0603 R's and C's? At my company, our designers have "opened the floodgates" on bottom-side 0603's. | | | | | | | | We've got an EPK+ with rotary chip and omega wave but can't seem to get skip-free so
Electronics Forum | Wed Oct 13 08:37:49 EDT 2010 | denisp
we have a static problem with 0603 led when removing the plastic retainer from the tape and reel. same problem with the feeder causing reject and bad placement. is there someone having the same problem? and how to fix it. thank you
Electronics Forum | Mon Jul 11 10:48:48 EDT 2016 | mnorthey
I have experienced this problem on a number of different machines and have found that it has been one bad nozzle causing the problem. We run Juki 3010 and 3020 and occasionally we have had similar problems. One question, is it bad placements on all 6
Electronics Forum | Wed Aug 28 03:16:14 EDT 2002 | bentzen
Hi. I have a huge problem with Fuji CP643 recognition of 0603 (1608) capacitors from PhyComp. The terminations appear round with no clear corner edges. I have used vision type 10 but also tried others without luck. For certain parts I have 10 - 20 %
Electronics Forum | Mon Oct 26 14:20:49 EST 1998 | Paul Brydges
Hi, My question is how close can you place smd 0603 chip resistors to each other with having an assembly problem? I know the pick and place machines don't need a lot of clearance, Iam more concerned about the court yard area around the component to
Electronics Forum | Mon Jul 11 10:59:50 EDT 2016 | mnorthey
Other problems on previous machines that we have experienced is that there was not enough board support under the panel or that the panel thickness was inaccurate. Both situations can cause parts to bounce off the PCB or not to be pushed into the pas
Electronics Forum | Wed Feb 02 11:48:48 EST 2000 | Christopher Lampron
Dave, Ashok mentioned that the end termination of the component were dull and grey. I have had similar problems with Murata components exibiting the same characteristics on the end terminations. As it turns out, they have some exotic plating material
Electronics Forum | Fri Oct 13 07:34:49 EDT 2000 | Wolfgang Busko
If it�s in reflow, do you see where the solder is going? If it�s in wavesoldering, how�s the orientation of the parts? Wolfgang
Electronics Forum | Fri Oct 13 15:26:20 EDT 2000 | Dave F
We periodically see chip caps with poor solderability. Often terminations are missing plating.