Electronics Forum | Tue Feb 28 11:38:04 EST 2006 | Chunks
What year? Also, check fuses.
Electronics Forum | Tue Aug 04 09:02:34 EDT 2009 | kpm135
We replaced the tactile sensor's linear actuator on a MPM Ultraprint 2000 HiE. Now we are getting a Tactile Hardware limit error every time we try to find the stencil height. I was hoping some one could explain why we're getting this error and any i
Electronics Forum | Mon Jul 29 14:57:18 EDT 2002 | pjc
Hi VMS, I think if any model it would be the one they sell the most to the Asia market, which is the UltraPrint 2000. By the way, the UP3000 is called the UltraFlex 3000 this week. The UF3K is the top-of-the-range machine, top $$$$.
Electronics Forum | Thu Jun 24 09:24:03 EDT 2004 | Rob
The smallest component we use is 0402. Solder paste is Kester 256. Printer is MPM Ultraprint 2000. Stencil is 6 mil. I didn't here anything bad (rework or whatnots) in terms of soldering of those components.
Electronics Forum | Fri Aug 06 13:06:57 EDT 2004 | adrnbntz
Recently was bought a MPM Ultraprint 2000 and need to buy the wiper paper so any one have a recomended type or seller. ? thx.
Electronics Forum | Mon Feb 27 13:33:03 EST 2006 | Robert
Our MPM 2000 screen printer machine has a problem. During the machine reset mode a warning message come up "Z lockout not operating". Does anyone know what fault could cause this?
Electronics Forum | Mon Feb 27 21:08:21 EST 2006 | ChrisG
I have never seen that message before, but you should check the Z axis driver card, and the Z home sensor. Do you hear anything when the axis tries to move?
Electronics Forum | Tue Mar 07 00:03:24 EST 2006 | rbodmer
i no longer work with mpm machine's but mpm has excelent tech service and there manuals have all error codes listed. www.speedlinetechnologies.com
Electronics Forum | Tue Mar 07 00:11:30 EST 2006 | jgarver1
Is this a new machine to your facility? I have seen MPM UP3000's give error while homing if the transformers are not tapped exactly at the line voltage. Just a thought.
Electronics Forum | Tue Aug 04 13:44:05 EDT 2009 | swag
Check your DIP switch settings on new driver. Not sure about calibration. Try QMPM for password.
.gif)
winsouce.jpg)