Electronics Forum | Thu Aug 13 05:28:45 EDT 2015 | dilogic
We had occasional problems and usually solve it by pulling out pogo pins slightly to extend them a bit... Also note that electric feeders have "reel empty" sensor that gives the same error message (if you are using cut tape strips without reel)
Electronics Forum | Thu Aug 13 09:25:48 EDT 2015 | rgduval
A lot of these are cut tape (I think nearly all of them)....and they're all on electric feeders.. hmm.....where can I find that reel empty sensor? That would certainly explain a lot! thanks, ..rob
Electronics Forum | Thu Mar 03 17:41:41 EST 2016 | travishemen
That is a Hover Davis feeder. We use them on our Fuji IP3s and a Universal GSM, they work great. Check them out at http://www.hoverdavis.com/
Electronics Forum | Wed May 03 13:27:32 EDT 2023 | dilogic
Genesis should work with pneumatic feeders, but not if Lightning heads are used. It's basically 24V transformer and some wires and fuses - you can do this "upgrade" by yourself, actually. Regarding cal. kit - it's the same as for GSM's but, again, no
Electronics Forum | Wed Jan 19 11:08:16 EST 2000 | Steve
Hello All, I am evaluating placement m/c's and I have looked at the Universal Flexjet. However we will be using both taped components and components from tray. The tray loader Universal use is much cheaper that their PTIF shuttle system, however I a
Electronics Forum | Wed Jan 19 11:02:26 EST 2000 | Steve
Hello All, I am evaluating placement m/c's and I have looked at the Universal Flexjet. However we will be using both taped components and components from tray. The tray loader Universal use is much cheaper that their PTIF shuttle system, however I a
Electronics Forum | Fri Dec 08 08:57:58 EST 2006 | MGC
Hello SMTnet, > > I would like to make a power > supply for Universal multi pitch feeders so I can > index them offline. How much voltage do I need to > get to what pins of the connector? Thanks. http://hoverdavis.com/Products/universal/mpup/uf
Electronics Forum | Thu Mar 08 06:45:30 EST 2001 | genglish
I am having a problem with a Universal GSM machine (Platform Tray Feeder)dumping trays with parts still in the trays, subsequently damaging the leads. Is it possible to program the machine so if any part is not picked from the tray in the matrices a
Electronics Forum | Wed Mar 17 09:39:04 EST 1999 | Mike Evarts
| I am in need of feeder that that will feed a 76mm wide tape @ a 60mm pitch to be used on a Universal GSM. | It is not a standard tractor feed, so it would require quite a bit of ingenuity. | Does anyone out there know of someone who designs and bui
Electronics Forum | Thu Oct 29 06:44:55 EDT 2009 | jeffreyj
Hey folks... been reading the threads here the last couple of weeks and don't seem to be getting any smarter (and given my level of ignorance about this equipment, I was sure I could only go up from here...). I've been an independent design engineer
