Electronics Forum | Sat Dec 10 08:26:14 EST 2022 | poly
That procedure all works perfectly, and I'm read through that section of the manual however... 12. Perform Feeder Teach. Refer to the Feeder Teach Voyager help topic. I can't find anything in Voyager that explains the feeder teach procedure for t
Electronics Forum | Sat Dec 03 01:07:29 EST 2022 | poly
I've got access to the universal manuals / voyager but I haven't found a section that describes the feeder teach setup process, I can pick up the teach slug onto the conveyor and then get into feeder teach but if I teach the corners of the slug as t
Electronics Forum | Thu Apr 18 14:22:39 EDT 2002 | eedllc
I agree with Steve Huey, as a former Field Engineer and Asian Customer service manager living in Hong Kong for almost 10 years with little blue, there has been an incremental hit on all of the OEM's combined profits.They needed a strategy and some sc
Electronics Forum | Sun Apr 30 16:19:37 EDT 2023 | ttheis
We paid Universal Instruments $500 to register one of our machines and that git us access to the manuals through their website. Contact Universal.
Electronics Forum | Tue Oct 09 12:28:08 EDT 2012 | jrcline43
Do you have or know of a procedure/manual for calibration on universal instruments HSC/Genesis/Flexjet feeders?
Electronics Forum | Thu Jul 19 11:39:46 EDT 2007 | jdengler
Did you buy this from an equipment dealer or an end user? If you bought it from an equipment dealer and they said manuals included I would call them daily with questions that a manual would probably provide until they give up and send you manuals.
Electronics Forum | Thu Jul 19 14:03:53 EDT 2007 | slthomas
Radial Leads (I've had IIs, IIIs, and Vs) do the job nicely, but they need weekly maintenance to keep them running. I don't know if you can get parts for them or not if you're not registered with UIC, but you WILL need parts for it. You will need al
Electronics Forum | Mon Jul 23 12:31:03 EDT 2007 | gmoritz
Have you tried running it in step mode? Yes, and more. The installer asked me to run a few tests: 1> Intentionally make the machine miss insert a part then put a part in manually to see how the leads align to the cutter head. 2> Push the re
Electronics Forum | Mon Aug 06 11:58:48 EDT 2007 | gmoritz
Do you have BEC (Board Error Correction) > on that machine, and if so, did they > give you the alignment plate for it? I don't know if we have BEC on the machine. I can't even search the 550 page manual that was finally sent to us in a pdf file
Electronics Forum | Thu Aug 02 22:33:24 EDT 2007 | simsj
We've had some experience with Universal's machines as well. Aside from the mechanical problems you're experiencing, that level of control hardware is susceptible to power spikes/fluctuations. Save yourself some trouble later on and get a good UPS.
.gif)
