Electronics Forum | Tue Apr 16 09:46:36 EDT 2019 | ttheis
We just bought a MVP Supra M machine and have put it under power but can not get the PC system to power on. I am following the power up procedure in the manual. Under power the conveyor controls work and the UPS backup turns on, but holding the key i
Electronics Forum | Mon Aug 04 18:10:36 EDT 2003 | dougt
When a UPS is used on pick and place equipment is it setup to continue to run the entire machine or is it just keeping the computer(s) powered up? How long will the UPS typically supply power to the machine?
Electronics Forum | Mon Sep 21 18:19:41 EDT 2009 | jlawson
Has it stopped all togather, or look like power problem. I fixed one of these things , was power issue , cold joint on Switchmode Supply to the touch screen controller and up she went again. This only if power to the PCB is faulty....
Electronics Forum | Wed Jan 07 12:18:37 EST 2004 | teamcanada
Standard boot sequence doesnt support proper power for vision. We boot up without power to camera amplifiers, turn on amplifiers post power up and vision is OK but Emergency Stop with Error Codes 9152 and 9154 pop up during production. Possible flaky
Electronics Forum | Thu Nov 19 21:34:09 EST 2015 | ttheis
We just powered up a used GSM1 for the first time and it seems to boot and initalize ok. It is running UPS 3.2.2c. The first thing we noticed upon initial power up is that there is a lot of 'noise' on the monitors. Is this normal due to being designe
Electronics Forum | Wed Mar 28 15:26:10 EDT 2018 | dleeper
one caveat to be aware of is the power requirements of many machines. Most 'industrial level' pick and place machines, as well as reflow ovens will require 3 phase power. it sounds like you are trying to set this up in an office type environment. Do
Electronics Forum | Fri Feb 05 11:56:58 EST 2010 | kjs123p
It should show up as a mass storage device. Not to insult you intelligence, but do you have the hard drive powered up? You need to power it up if you haven't done that.
Electronics Forum | Fri Jan 12 11:46:26 EST 2018 | emeto
I don't know this exact oven, but usually it goes like that: First is a three phase power, then it is a contactor that is switching the power for the heaters and fans. than there are transformers for lower voltages. then there might be UPS system in
Electronics Forum | Wed May 26 07:11:04 EDT 2004 | pjc
Cut the main power (ciruit breaker) while the oven is operating (in low temp recipe) to see if the UPS kicks on, otherwise consult the oven manual's UPS electrical diagram. UPS is to power conveyor drive and PC controller. Also, checking the UPS manu
Electronics Forum | Wed Jul 03 09:43:47 EDT 2019 | SMTA-Pat
Hello All, Just wondering if some viewers on the forum have experience with conformal coating of PCBs for high power electronics. High power in this case meaning up to 800v. Any comments with regards differences seen from standard 12/24v electronic
