Electronics Forum | Thu Nov 08 12:50:22 EST 2012 | jmartens1978
I have a project that I am working on and would like some input from anyone that has some knowledge on High Voltage Arcing on PCBs. Problem: I have a PCB that is enclosed in a plastic enclosure that has metal pins and switch that extend to the outs
Electronics Forum | Thu Jan 31 10:21:25 EST 2013 | rway
Thanks for the reply. Yes, that is pretty much what I found out. I had to send both the Unicor display and the PLC back to Simplimatic Automation to be reprogrammed. It was the Unicor that lost its memory, but they like to see the units operate to
Electronics Forum | Fri Feb 01 08:11:43 EST 2013 | bdamico
Hello Phase1, Depending upon where you purchased your system, chances are that you are running a very old version of software and that the MIL library is also out of date. This will have a big impact on the functionality of your MIRTEC machine. I t
Electronics Forum | Wed Feb 13 07:00:59 EST 2013 | spoiltforchoice
Low-Medium volume and Low Budget are difficult for others to quantify. I'm not familiar with GEM's but if the AX-201 suggested above can use your existing feeders its obviously got a leg up on the competition. Otherwise, to some extent your choice mi
Electronics Forum | Thu Feb 28 10:40:56 EST 2013 | rway
I have been doing this since day one of getting the AOI. It just seemed logical. I don't know what type of AOI you have, but what I have found works best is to use solder inspection to catch parts that are loaded into a no-load location. Move the
Electronics Forum | Tue Mar 12 07:46:26 EDT 2013 | ngineer
bobpan, It only happens with this program. CC ver 7.54, IVC V 3.05 If i leave CC out of it, and edit the sequence using the HHT, it sticks. but if i download from the assembler to CC, it's messed up. if i then fix it in CC, the minute i save
Electronics Forum | Tue Apr 02 12:53:47 EDT 2013 | microaide
I have entered my machine configuration as much as I can figure it out. I will have two machines. One with tape feeders, and the other with vibratory (tube) feeders and a waffle feeder. I've tried to set this up as best I can. But I get to the screen
Electronics Forum | Wed Apr 03 16:07:13 EDT 2013 | microaide
OK, so I think I have figured out the machine configuration for tape feeders. BTW, your procedure for retrieving the X/Y/Z coordinates for the pickup locations was wrong. So I looked it up in the Quad manual. The manual was wrong too. Correct procedu
Electronics Forum | Wed May 22 14:17:13 EDT 2013 | ericrr
As the subject says, the trouble started when the computer (Windows 98) drove me nuts starting up in the morning. The Engineer comes along NEVER ASK ME ANYTHING, and thinks the network should have some network protocol (Example equivalent to TCP/IP
Electronics Forum | Sat Jun 01 11:15:34 EDT 2013 | aemery
Delete the program and start over. I can't get a clear understanding the way you described the error, but it does sound like you have some kind of detent issue or a board stop programming issue. Depending on the configuration of your machine and th