Electronics Forum | Fri Nov 03 02:32:56 EST 2006 | shivam
HI ALL, can anybody clear me what is via tenting and via pluging?? second one, if i use via in pad for an.5mm bga what care i should taken, what should be the soldermask open in top and innerlayers for via?how it will directly connect to top layer
Electronics Forum | Fri Nov 03 07:28:27 EST 2006 | davef
Via filling methods are: * Tenting * Plugging * Capping * Flooding Tented Via. A via covered with dry film soldermask; the via is not filled. When tenting from both sides there may be issues with trapped air that expands during mass soldering. Plug
Electronics Forum | Tue Dec 22 17:32:17 EST 2020 | atpico
We are looking to buy a 2nd hand Europlacer p-n-p. We would be very grateful to have a real production competent opinion about EP feeders/trolleys Questions: 1. generally how good/bad are older (Gen1, Gen2) Europlacer feeders and trolleys systems
Electronics Forum | Wed Dec 30 13:26:55 EST 2020 | atpico
Hello Dave, Thank you. I certainly look on Used Equipment Mart section. The question was if Gen 1 feeders/trolleys worth to invest or better try to buy EP Gen 2 feeders/trolleys even if significantly much expensier/rare on used machines market.
Electronics Forum | Tue Jan 05 07:31:34 EST 2021 | atpico
Great! Thank you! What about Gen1 vs Gen2(NT) EP feeders (not feeder elements)
Electronics Forum | Tue Jan 05 07:48:39 EST 2021 | mbass
Go for Gen 2 NT feeders, the Gen 1 Feeders tend to be problematic the older they get whereas the Gen 2 feeders are a much better prospect. I've used 8, 12, 16, 24 and 44mm. Some problems to look out for is pull back of coverlay and removal of waste
Electronics Forum | Wed Dec 23 02:16:46 EST 2020 | davef
Used Equipment Mart [nav bar on the left margin of your screen] * SMTnet > Used Euipment Mart > RFQ [nav bar on the left margin of your screen]
Electronics Forum | Mon Jan 04 10:47:48 EST 2021 | mbass
Hi, As a user of EP P&P machines for over 20 years I have used Gen 1 & Gen 2 Trolleys. If you can get Gen 2 Trolleys with Elements that would be the preference as there are a few options available on the Gen 2 not on Gen 1. That said the Gen 1 Trolle
Electronics Forum | Thu Jun 15 22:03:32 EDT 2006 | Frank
You are correct, the Hover Davis label feeder works on 'un-punched' flat carrier. Get a sample of your dots on the tape and send it to Hover Davis to see if their feeder will work for you. The Hover Davis feeder will peel the dot off of the tape so
Electronics Forum | Thu Jan 21 02:26:30 EST 2021 | baldoino
I would like to sell used pick and place feeders for Siplace. How can I offer them (70 x 8mm; 20 x 12/16; 05 x 24mm.
winsouce.jpg)
.gif)
