Electronics Forum | Wed Apr 09 09:48:49 EDT 2003 | iman
after oven bake dry the PCB, we process within 4-hrs, else need to rebake again under same baking parameter. taking a look, the exact pads with the blowholes are full ENIG pads with no via holes under the solder-intend land areas. In event there is
Electronics Forum | Fri May 22 22:13:27 EDT 1998 | G. Henning
Thanks for the advice. We are experiencing only limited success with SMT on the drag. Problems are indeed bridging and misses on the smaller discretes. Works well on PTH as long as the pitch is not too tight. I'll have to justify a new machine. Rega
Electronics Forum | Wed Sep 22 22:32:40 EDT 1999 | Dave F
| We are finding solder shorts under 1206 Components on the bottom side of our boards.In all cases these shorts are from either side of the component to a feed-thru under the component body. Adhesive is used to glue down the component and then the bo
Electronics Forum | Thu Oct 01 11:40:17 EDT 1998 | Justin Medernach
Are there anyone who can give me the answer about solder ball problem? | We have 12 layer PCB and double sided PCB. After one side reflow soldering We found lots of solder ball under the PCB. The solder ball was coming out from via hole. | So
Electronics Forum | Fri Feb 22 14:22:07 EST 2008 | stevek
Are you using nocleans, especially when you get to SMT? Years ago, I had OA wave flux get into vias that were plugged from the top under parts. It is really difficult to clean small, high aspect ratio vias. Cross sections showed that the copper in
Electronics Forum | Mon Sep 20 13:04:25 EDT 2004 | davef
The Intel BGA Developer�s Guide [ http://developer.intel.com/design/packtech/ch_14.pdf ] says: 14.8.3.3 Plated Through Hole (PTH) Isolation Regardless of the technique used for the mounting pads shape or definition, isolation of the plated through h
Electronics Forum | Thu Oct 01 06:44:44 EDT 1998 | PARK KYUNG SAM
Are there anyone who can give me the answer about solder ball problem? We have 12 layer PCB and double sided PCB. After one side reflow soldering We found lots of solder ball under the PCB. The solder ball was coming out from via hole. So when w
Electronics Forum | Thu Feb 07 20:53:51 EST 2002 | davef
Regardless of the technique used for the mounting pad shape or definition, isolation of the plated through hole [PTH] from the mounting pad is important. If the PTH is contained within the mounting pad, solder will wick down the PTH. The amount of
Electronics Forum | Wed Feb 20 16:52:11 EST 2008 | pms
Yea, I'm still here.....sigh. Got bridging problems. These assemblies are SMT topside, then go thru wave for thru-hole components on topside. These assemblies have many, many, many vias VERY close together. We have a problem with solder from the wa
Electronics Forum | Sat Jan 22 20:59:51 EST 2000 | Jeff Sanchez
Michael, I am not sure if you are trying to lay out a board with vias in the pads or suffer through an assembly you got stuck with? I am building run of boards right now that has vias in most the smt pads. I'm sure the design group thought it was
