Electronics Forum | Sun May 02 17:58:21 EDT 2010 | bruceb
When my DEK 265GSX boots I get a vision error1 and am asked to reinitialize. I cannot get into mainenance mode to troubleshoot. DEK told me over the phone that I have a bad Cognex card and it would be $20k to repair. This is crazy, has anyone seen th
Electronics Forum | Mon May 03 08:09:04 EDT 2010 | Jeff
Power up your machine and look at the vision card. If it has a red light then there is a problem with it. 20k is way to much to spend to fix this. I've sent out two cards for repairs in the past and got them fixed for $2200 each. If you want more inf
Electronics Forum | Mon May 03 17:14:36 EDT 2010 | stepheniii
If I remember correctly the best solution was to turn the shuttle off. I don't think we ever found any real benefit to using the shuttle. On some machines a shuttle is great but IRCC not so much on this one. Do some time trials to see if using the sh
Electronics Forum | Tue May 04 09:45:05 EDT 2010 | dyoungquist
Only use the shop air if it is clean and dry. I know from experience that one can get water and a little oil from the compressor in the air lines. We are in a drier climate with humidity levels in the 25%-35% range on average. All we do is let the
Electronics Forum | Fri May 07 01:50:28 EDT 2010 | tonaxel
Hello, I just have a bit problems with one TM8 what is not always able to put the parts in the right pick position. The wheel with the part stops very often before the pick position. Does anybody have a service manual for the TM8? Thank you very muc
Electronics Forum | Fri May 07 13:28:13 EDT 2010 | tonaxel
Hello SR.Tech, yes, the general positions from 1 to 16 are ok. I also changed the pressure of the spring what is on the achsis for the tape transport wheels. This helped a lot for the most wheels but not for all. I will try it again. Maybee the pres
Electronics Forum | Fri May 07 15:58:36 EDT 2010 | smt_guy
I'm looking for an optical scope that can penetrate through a gap of 0.005" to 0.010". Is there anything available in the Electronics / Semiconductor Industry for this kind of application? I want to see what's inside that size of gap for solder short
Electronics Forum | Mon May 10 10:53:20 EDT 2010 | dilogic
Does anyone have some experience with AIS3500 on GSM1? It stopped to function just like that. I've opened it to check the batteries and I can see 4 status LED's blinking in a constant pattern, but I can't get any response over seial line from it...
Electronics Forum | Thu May 13 17:08:38 EDT 2010 | gregcr
prompt appears hit enter, another prompt should appear. Now set Diagnostic/Run switch to run, start vision system software load. The vision software can not load if the system is in running arbitrary code and hung in a loop so halting the controller
Electronics Forum | Fri May 14 02:04:16 EDT 2010 | dilogic
Sorry for not clearing that out - it's not the problem of lost vision sw. - I even can't connect to it in diag. mode. Must be some hardware issue. I've checked video outputs with the scope and instead of constant freqency ~15kHz, it drifts up and dow