Electronics Forum | Tue Feb 18 16:13:04 EST 2020 | bk
Just by looking at your attachment and seeing that error, I would say that you didn't put in the magic word when you reloaded your software or mistyped it if you did. If you don't have your magic word you will need to contact mydata or whoever you bo
Electronics Forum | Wed Feb 19 12:08:32 EST 2020 | jactomas
Hi, Really thanks for your answer. When I had this first issue, the machine was working correctly, and for some reason started to show this error code. After that, -I reinstalled the TpSys, and I didn´t put the magic word, waiting that my recovery
Electronics Forum | Mon Mar 09 08:31:32 EDT 2020 | jactomas
Solved!! Finally it was the CPU board, I changed this and has started running perfectly. It is my opinion that the problem coming from GPU of this board, but I will never know this. by the way, I have receive a incredible support from Julio from PFI
Electronics Forum | Fri Feb 21 11:35:11 EST 2020 | emeto
Hey just solders and QA people don't like it. As long as management likes it, who are these to argue? Fire them all and hire people that like cameras better. Now seriously - people who work with it should have the final word. You can also have both
Electronics Forum | Wed Feb 26 11:31:42 EST 2020 | philc
I use a stereo microscope (Mantis) and find it way better for soldering/rework than a camera system, which we also have here. The camera system does NOT give you the same 3D-type of image that the Mantis does, BUT, there are times when you are inspec
Electronics Forum | Fri Feb 21 10:50:00 EST 2020 | tomdegas
I am getting the following error on our MY9 during hardware initialization: F-MOT-MSEDYN HYDRA Z/156 Motor Timeout After the Theta test, The HYDRA head moves slowly all the way to the bottom and then moves slowly back up and the system fails initia
Electronics Forum | Wed Mar 04 13:45:01 EST 2020 | tomdegas
I appreciate the help. The Hydra travel is fine and goes down and back up with no trouble. I swapped the Z Mot board with the Y Mot board with no change. The long ribbon cables were changed about a month ago but I will inspect them again to be sure.
Electronics Forum | Thu Mar 05 07:40:55 EST 2020 | tomdegas
I swapped the mi boards with ones from a working My12 machine and the same results. To recap my problem: On "Hardware Initialization" the center jaws open and close, the Hydra Theta belt moves back and forth, the Hydra head moves all the way down an
Electronics Forum | Tue Feb 25 15:28:07 EST 2020 | SMTA-Alex
TPSys is the machine operating system, proprietary from Mydata (Mycronic, now). It's based on Linux. You have to purchase the upgrades from Mycronic. Depending on which version you're upgrading from, the cost might vary. If the machine you're buying
Electronics Forum | Mon Feb 24 14:40:02 EST 2020 | tristanlund
Hello, we recently got an S3088AV viscom aoi. Following the instructions for programming with cad data I get to almost the very end and a command prompt shows up with this error that I have attached as a picture. I have redacted that customer board n
