Electronics Forum | Wed Mar 17 04:26:44 EDT 2010 | mun4o
Hi, we have vitronics delta 6622 in your production.Problem with fluxer starting 3 weeks ago.Fluxer moving, but not spraing????I check flux system , and dont find any problems with machine.Clean the spray nozzle with compressed air , but nothing.may
Electronics Forum | Tue Jun 14 11:57:21 EDT 2005 | ??
Are any of you guys out there using the vitronics xpm oven's having problems with the muffin fans dying on the top of the oven. Seems to me that they are using an inferior muffin fan that is not rated for the environment they are in. The fans have sl
Electronics Forum | Tue Jun 14 15:47:41 EDT 2005 | OverTheHill
Yes, the original fans were junk. I replaced them all with a ball bearing type. No problems for 3 years now. Manufacturer----- Rodale Phone No. 1-714-283-3140 Part No.---------- RC-A12M15HTB I think they were about $25.00 US bucks each back th
Electronics Forum | Fri Dec 15 01:37:21 EST 2006 | shrikant_borkar
Hi, Hemendra Recently, We have carried out lead Free Soldering On our 4+1 Panasonic Reflow machine. Results were fine , but its Not Recommended for long Run. but the machine which you have is 5 zone machine and additional 2 cooling zone too. Check
Electronics Forum | Tue Mar 23 09:31:39 EDT 2010 | rmitchell
Hi, To provide closure and help the healing process and maybe benifit someone else down the road... The problem was the UPS battery had gone dead. Back side of oven, near the exit end. rob
Electronics Forum | Fri Mar 05 08:06:39 EST 2010 | rgduval
Rob, Had that issue early on when we hooked up our Heller. For us, the problem turned out to be the serial communications port on the computer. I can't say we had the black screen, but, we had comm errors. I'd check the following: 1. Cable betwe
Electronics Forum | Mon Aug 18 06:30:23 EDT 2014 | nhel_0009
Hi guys. Kindly help me on our reflow (vitronics soltec). My problem is the n2 value reach 10014...any possible solution or suggestion guys..
Electronics Forum | Mon Aug 18 06:35:44 EDT 2014 | nhel_0009
Hi guys. Kindly help me on our reflow (vitronics soltec). My problem is the n2 value reach 10014...any possible solution or suggestion guys..
Electronics Forum | Thu Apr 24 06:33:07 EDT 2014 | sarason
Since you are chasing down communication errors as a likely root cause of your problem. Perhaps the RS232 COmmunicaions chip was taken out as well. This was a common enough problem in glorious days gone past fixing really old RS232 gear. ALso caps Po
Electronics Forum | Tue Apr 22 07:39:16 EDT 2014 | hemant_pang23
I have problem with the 6241B Combi inseration machine The PC showing the Error Massage as " NO STATUS MASSAGES FOR THIS MACHINE " We have changed the ICs DS14C88N , DS3487N & DS3486N but of no use since getting same error massage Pls help us to res
