Electronics Forum | Mon Sep 05 11:51:30 EDT 2022 | jojoled
Can anybody help with Re-calibrating the Z-axis height in MS parameter , on JUKI KE760L? In MS parameter manual, there is information that these accessories are needed to recalibrate the Z-axis , can anybody tell where to get them, or ideally how to
Electronics Forum | Thu Jul 20 17:03:09 EDT 2000 | Darby
Ketan, If you are using a z-axis head, pay very careful attention to the pick up height so that you don't force the head into the component. Also pay very careful attention to the placement height, we set the component height to 0.05 to 0.1mm over th
Electronics Forum | Tue May 29 17:24:28 EDT 2001 | hussman
OK, I have a new product being tossed over "the wall" that has a flex circuit layered into a standard FR board and protrudes out of it. The flex circuit is 0.022" thick and is the 3rd layer of 6 layers. The total board thickness of the FR board is
Electronics Forum | Tue Apr 01 07:45:55 EDT 2008 | aj
Hi, We use the standard pin supports when necessary. Are your boards very thin i.e less than 1.6mm ? or maybe panelised ? Other things to check are Z0 placement height aswell as damaged nozzles,sticky nozzle/nozzle head , poor feeders along with t
Electronics Forum | Thu Jul 07 19:39:18 EDT 2005 | darby
This is a very difficult question to answer as it will depend greatly on your component mix. I will presume that the CSM 84VZ is of the following configuration: 2 x RDC Synchro Heads. Heads 1 & 2. These are mechanically centering heads with a chucki
| 1 |
winsouce.jpg)