Electronics Forum | Fri Feb 15 15:09:24 EST 2008 | soudomphong
Anybody have any idea where to get the cutter motor for siplace 80-S20 with reasonable price? I am also looking for S20 head board, and a Y-axis motor. Any help would be much appreciated, thank you.
Electronics Forum | Fri Sep 11 12:44:16 EDT 2015 | simons
Our Philips Orion shows a L049 motor error immediately after we turn it on. Note that the Y axis servomotor was very hot prior to the last shutdown. Is this a problem with the motor or one of the boards?
Electronics Forum | Thu Nov 10 18:58:38 EST 2005 | darby
What is the problem Peter? See a recent posting on a Y axis problem with the same style of machine. If the encoder is cactus, buy a new motor. Sorry, this is the only solution I know of.
Electronics Forum | Wed Sep 04 20:29:56 EDT 2013 | saibot
We had that problem a few months ago with one of ours. Had to replace both y-axis motors and the tech said it's a common problem with the Opal-XII.
Electronics Forum | Fri May 10 11:23:21 EDT 2019 | sumitsingh
Are X & Y axis motors affected because they may "climb" or "Moves down" as machine is not leveled up?
Electronics Forum | Mon Nov 17 00:13:46 EST 2003 | shawn
if george idea doesn't solve ur problem then it must either be the driver or the y-axis motor itself.try swaping the driver with other machines if u can afford it . good luck.keep me posted of the developments.
Electronics Forum | Thu Oct 27 03:15:14 EDT 2005 | Jeff Roberts
The Y-axis motor of the YM84 Series is well known for failures. The bearing between the encoder and the armature fails causing dirt to fall on the encoder wheel, hence the encoder mis-counts. If you re-Origin the machine the problem is resolved for a
Electronics Forum | Thu Feb 15 12:45:44 EST 2007 | chrisgriffin
If you think you are having lighting issues, you should do a histogram test. It's under the test user. There is a pot on a power supply that will adjust the brightness. The power supply is right next to the Y axis motor. There should be a brown p
Electronics Forum | Mon Sep 14 16:36:40 EDT 2015 | simons
Upon start up our QSA machine is giving us the following errors. Cant reset motor alarm (x axis) Cant reset motor alarm (y axis) Cant reset motor alarm (z axis) What are the possible reasons for this? Thanks
Electronics Forum | Tue Oct 25 09:20:10 EDT 2005 | meritajs
Hi, We have problem with y-axis offset at YM84 After setting the ORIGIN machine operate exactly but after sometime y-axis recieves offset bis 5-10mm.After repeated setting ORIGIN Y-coordinat became exact. The same things take place if we operate in W