Electronics Forum | Thu Feb 01 02:36:40 EST 2007 | bvdb
Hi pr, The problem was happening on all three of the nozzles that we were using, about half the time the Z axis would rise up and go for the next nozzle and the other half it would stop almost as soon as it released the nozzle. When I inch the Z ax
Electronics Forum | Wed Mar 25 15:12:14 EDT 2015 | marcelorotofrance
Hi, Bob you're right. I replaced the Z-rod and the machine started to go alright. When I examined the head's mechanism I omitted to check the most exposed an delicate part... my bad. The old Z-rod came with the machine, and its slide movement was loc
Electronics Forum | Thu Mar 26 10:42:16 EDT 2015 | bobpan
Glad that I can help.... Bob
Electronics Forum | Tue Jan 17 12:00:14 EST 2023 | dbrenkus
I sent a link to the manual in an email.
Electronics Forum | Tue Jan 17 12:17:04 EST 2023 | eurolan
I appreciate it, thanks for your help!
Electronics Forum | Thu Jan 19 07:43:54 EST 2023 | bukas
there is a special tool(cable) used to phase the motor with driver.
Electronics Forum | Tue Feb 20 02:35:21 EST 2024 | erikfriesen
If possible, I'd like that service manual, thanks.
Electronics Forum | Thu Feb 22 08:27:32 EST 2024 | micropak
May I request the Service Manual ?
Electronics Forum | Thu Feb 22 13:25:59 EST 2024 | micropak
Thanks a Million..
Electronics Forum | Fri Jan 06 09:39:35 EST 2023 | micropak
In newer machines, after changing a motor you have to do an "Axis Home Calibration". Once I changed Z-Axis belt on an SM-482 and it refused to successfully do "Axis Home Calibration. Then the solution was to remove the belt, rotate the motor pulley a
winsouce.jpg)
.gif)