Electronics Forum | Thu Apr 26 13:16:28 EDT 2018 | bobpan
I am trying to figure out how to teach the position of the tooling so that its aligned to the hole in the worknest. In other words...the carousel is out of position. When i go into machine calibration and i step through it the process freezes at a st
Electronics Forum | Wed Apr 17 13:48:32 EDT 2024 | jdengler
I have a AIMEX III and we have seen the top cover on the conveyor being pushed out of postion when someone does maintenance. I beleive the NXT's use the same configuration. Check to see that the cover is pushed all the way over where the PCB would
