Electronics Forum | Wed Jan 11 15:21:51 EST 2012 | pr
Can anyone recommend fans to put on the conveyors post reflow? Thank you, PR
Electronics Forum | Mon Oct 08 14:56:10 EDT 2001 | Mike
I think the problem is going to be the cooling zone location. All of the heat zones are built the same, but the cooling zone can not be moved easily.
Electronics Forum | Tue Oct 09 11:50:44 EDT 2001 | Marc Peo
Hello Darby! Mike is correct in saying that reversing the conveyor can be done but the position of the cooling zone would be troublesome. I am guessing that you are looking at a left to right machine that you would like to run right to left or vice
Electronics Forum | Wed Jan 16 10:52:19 EST 2008 | kbhatia
R SMT line flow to a R->L flow after the 90 degree turn. We have some equipment that is R->L and wish to interface to the end of this line. So the flow is oven (with enough air blowers that the 8040 is cool) -> 8040 turnstyle to move LEFT (technicall
Electronics Forum | Fri Dec 19 10:15:24 EST 2003 | haviland
Bill--Good morning. We have several decline conveyors w/ conductive black belt Plus cool down units w/ banks of (8) fans. I believe the belt widths are 18". Would that work? Everything is in Illinois. Thanks, Nick Haviland, Electronic Assembly Machin
Electronics Forum | Mon Feb 10 10:41:29 EST 2020 | SMTA-Tony
Hello Phil, As the other respondents have mentioned, the cooling rate is not easily controlled and varies based on the oven and board design, as well as the settings of the last few zones and cooling zones. In general, the board is going to cool in
Electronics Forum | Thu Jun 16 22:18:35 EDT 2005 | davef
Cooling may require muff fans positioned over that output conveyor of the oven.
Electronics Forum | Fri Sep 22 06:59:45 EDT 2000 | jackofalltrades
For several years now we have been using a short (4 feet) conveyor with brush wheels and a simple box fan mounted under it (blowing up) to cool the product.
Electronics Forum | Mon Mar 20 22:08:24 EDT 2023 | tey422
For reflow oven to "auto off" it has to go through the cool down; it should be off went the cool off temperature is reached. Perhaps you need to 1st check if something prevent the oven reach the cool off temp (both hardware & software).
Electronics Forum | Thu Sep 18 11:07:39 EDT 2003 | donbell
SR. Tech: I have worked with Omniflo 7 and 10 ovens for many years. I purchased several 10 zone ovens in '98 when I worked for Ericsson. Here are some of my experinces with Electrovert Omniflo ovens; Yes, you can expect to run the conveyor speed a