Electronics Forum | Fri Feb 09 15:21:12 EST 2001 | larryk
Ours works good with the inspection of components, but looking at solder joints has a lot to be desired. There is lots of new names in the AOI business. Like any other equipment, do your homework. Ours has had their share of problems, but I think it
Electronics Forum | Wed Apr 22 19:21:42 EDT 1998 | Phillip Hunter
Check with Fuji America Corp. 847-913-0162 ask for service department and/or your local sales rep. I have a quote for a 72mm feeder from Fuji for an IP3 ($ 7,000). Oh yeah, These are customs from Fuji and have no Part Number. (What are you placing
Electronics Forum | Mon Sep 23 17:53:01 EDT 2002 | steveb
We have both Panasonic MPA3 56mm feeders and Hover-Davis 56mm feeders. You can go wider than this if you need, we also have a 72mm Hover-Davis feeder. You are correct in stating you will need to base plate for the Hover Davis feeders to work. We h
Electronics Forum | Tue Dec 17 11:01:24 EST 2002 | Tim Marc
Hello all, One of our PCB manufacturers coated a through hole connecters vias with solder mask. The only IPC references that comes close to describing this problem is 2.9.2 Registration to holes, and subsequent specification 6.3.1 PTH � Vertical fil
Electronics Forum | Wed Oct 25 11:25:12 EDT 2017 | paddyronan
Hi all, I have a recent issue with an IP3 machine. The machine cycles through normal power up routine. Then the video monitor and VME card shit themselves down and after a couple of minutes the CPU board powers down. However this is intermittent. Wh
Electronics Forum | Tue Mar 16 15:59:40 EST 1999 | GSM GURU!
| I am in need of feeder that that will feed a 76mm wide tape @ a 60mm pitch to be used on a Universal GSM. | It is not a standard tractor feed, so it would require quite a bit of ingenuity. | Does anyone out there know of someone who designs and bui
Electronics Forum | Thu May 06 13:19:57 EDT 2004 | fmonette
Hi Rob, You might want to consider changing your current procedure. Components classified MSL 4 have only a 72 hours floor life at 30C/60%RH. Even if you consider the de-rating factor (table 7-1 in J-STD-033A), at 50% this maximum exposure time wil
Electronics Forum | Thu Jul 12 11:56:20 EDT 2012 | hegemon
You might try to complete all your soldering within a 72 hour or less time frame. For all intents treat your board like a moisture sensitive component after you have baked and completed SMT reflow. Wash, blow dry, and go direct to stuffing and com
Electronics Forum | Tue Dec 17 16:27:02 EST 2002 | davef
I�m not clear on the problem. What I get: * Your fabricator did not deliver the product that you asked for in your purchase order. * Pad. Land. A portion of a conductive pattern used as a termination area. Metal surrounding a hole on a printed ci
| 1 |
