Electronics Forum | Fri Feb 13 18:08:06 EST 2004 | bman
We have recently aquired an MPM SPM stencil printer with an under stencil wiper. I have a list of approved solvents from MPM, but before I go and buy one I thought I would see what the fine people of SMTnet are using for their wiper solvent needs.
Electronics Forum | Thu Apr 14 06:54:02 EDT 2005 | teera
hi! below are the item need to check: 1)top plate condition(under screen squeegee). 2)under screen clean contact position(with stencil) 3)make sure the thickness of wiper paper not so thick(not over 6o gm)becaue it will effect the vacuum suction. 4)s
Electronics Forum | Thu Aug 13 19:54:01 EDT 2015 | aemery
The camera assembly is designated as X23; the stencil & board lighting as well as the camera video signal pass through the DB9 connector at the camera. There is a ribbon cable in the vision gantry tray that carries both to the box on the left side o
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
Electronics Forum | Wed Sep 08 08:25:26 EDT 1999 | Brad Kendall
Listed below are the issues Viking has been experiencing since the | installation of the Proflow Head: | 1. After installing new 350mm Wiper foil with metal | strip glued on it, It worked for about a week and suddenly meta
Electronics Forum | Thu Aug 06 09:51:20 EDT 1998 | Bob Willis
This text may be of interest to any one with tin lead spots Guide to Solder Spots - A New Plague in Manufacture ? So what are solder spots ? They appear to be the next big problem in modern reflow assembly in fact in any process that involves solder
| 1 |
