Electronics Forum | Fri Nov 07 06:06:27 EST 2003 | loz
Tape and reeling services as follows:- Specific Components Ltd. Tel. 01257 279944 Others available are Action Circuits, in Luton. Intosert in Northampton. Sorry no contact details for above. Loz
Electronics Forum | Tue Aug 17 15:58:14 EDT 2010 | rob_thomas
IPC-7711/7721 states under Scope section: "This document does not limit the maximum number of rework, modification or repair actions to a Printed Circuit Assembly". This is from Rev B of this standard. There are many factors that play a role in the d
Electronics Forum | Fri Dec 13 15:40:53 EST 2002 | pjc
Too many British. Maybe some below can refer you to Dutch or Belgian companies. SMD-Taping Service Bartholomaeusweg 8 D-91522 Ansbach Germany Tel. / Fax: +49 981 17356 Tel.: +49 981 9724363 Fax: +49 981 9724364 www.smd-taping-service.com Reel Servi
Electronics Forum | Wed May 28 08:25:08 EDT 2003 | davef
That's what we do [no more than three reworks or mods]. Your "four reworks permissable" was probably based on the 55110 five thermal cycles, counting wave soldering as the first cycle. How do you plan to keep track of each of those rework actions?
Electronics Forum | Sun Oct 18 11:48:50 EDT 2009 | Rul
Problems found are the machine frequent freeze suddenly and produce error message when homing the machine: servo devices failed ... Action taken. Change the pc with another working machine. result= same problem happen. check the fuse at circuit of t
Electronics Forum | Thu Jun 09 14:19:36 EDT 2022 | emeto
Are these still in action? I thought can't find any support for these anymore.
Electronics Forum | Thu Aug 16 22:12:41 EDT 2007 | davef
There is limited benefit to silk screen legends. They cost ~$45 a side per batch. There is benefit to some board users in having reference designator and orientation markings as an aid in test and repair actions. There is no reason these markings
Electronics Forum | Tue Dec 31 01:58:19 EST 2002 | MA/NY DDave
Hi Sorry, even though I have seen a machine in action by a test engineering department years ago, and remember some advertisements since then, and maybe have seen one at a show, I don't remember the names of the companys. If I had to I could probab
Electronics Forum | Mon May 12 04:26:00 EDT 2014 | gazelle
Hello - I am looking for a source to supply low thermal EMF solder - can anyone provide pointers ? In the past a cadmium - lead alloy was used for this, but these are banned (RoHs) ... - the aim is to minimize thermo-couples on a very sensitive 4 lay
Electronics Forum | Thu Jan 27 08:52:05 EST 2000 | Todd A. Braun
We currently use a silicon conformal coating on many of our manufactured circuit boards and are experiencing situations where the coating doesn't conform. For example, on the sharp edges of components and corners of leads it pulls away before curing
.gif)
